Home 
Home Search search Menu menu Not logged in - Login | Register
> Brett Gibson JH5 20497

Profile Topics Posts
Posts by Brett Gibson JH5 20497
734 postsShowing posts 41-80 of 734

Miscellaneous > Jensen East Coast Nationals 2017 (7 replies - 3128 views)

Last bump of 2016. ...   12-30-2016 07:00 pm

Wheels > Refinishing/restoring the stock JH wheels (16 replies - 8472 views)

Do Stag rims fit a JH ?? and if so are they 13 or 14 inch. Brett ...   12-24-2016 01:16 pm

Miscellaneous > Jensen East Coast Nationals 2017 (7 replies - 3128 views)

FYI, hope to see some new face's Mark Your Calendars......The 2017 Jensen East Coast Nationals "Back Roads and Covered Bridges will be held in Dorset, ...   12-22-2016 01:12 pm

Electrical & Instruments > Wacky Tachometer (9 replies - 3241 views)

From what I'm told that is the correct ohm's for optic ignition, have you tried running some temp. wires to the tach to see if ...   12-12-2016 04:31 pm

Electrical & Instruments > Wacky Tachometer (9 replies - 3241 views)

What size coil, and do you have a ballast resistor in the circuit. ??? Brett ...   12-12-2016 01:14 pm

Body & interior stuff > Front Window Source (2 replies - 1620 views)

I have a Pilkington in my car since 2003, good fit no issue's, I did get it professionally installed and they used a 1" bead ...   11-19-2016 06:56 pm

Engine & Transmission > Installing the intake manifold (9 replies - 3408 views)

The two in question are the ones under the round holes for coolant, they end up being partially blocked by the Strom's float bowls. Most ...   11-17-2016 12:59 pm

Electrical & Instruments > clock repair vendor? (12 replies - 3882 views)

There is a old old post and an article in the JHPS Standard about a member swapping the cuts of the clock with a battery ...   11-12-2016 01:30 pm

Engine & Transmission > Installing the intake manifold (9 replies - 3408 views)

Frank, I sent you some photo's, those two threaded holes do NOT have any studs in them and are NOT used. Brett ...   11-12-2016 01:25 pm

Electrical & Instruments > Wiring Harness Installation (6 replies - 4764 views)

I have the photo's but not your e-mail address ? your PM did not include it. ...   11-10-2016 07:52 pm

Electrical & Instruments > Wiring Harness Installation (6 replies - 4764 views)

PM me with your e-mail and I will send you a few photo's. Brett ...   11-09-2016 12:37 pm

Engine & Transmission > Belt idler pulley and bearings. (56 replies - 15592 views)

I am in the process of bolting things back onto my rebuilt engine, and in doing so when I looked into the belt tension-er whole ...   11-08-2016 12:47 pm

Miscellaneous > Wiring diagrams (2 replies - 1270 views)

Frank, I just e-mailed you the three diagrams that I have, hopefully one is what you are looking for. Brett ...   11-01-2016 01:41 pm

Fuel Stuff > Reversal of fuel rail? (5 replies - 2133 views)

Fluid dynamics come to mind when changing fluid flow paths. The more fittings and types of fittings, you create resistance, resistance reduces flow volume (not ...   10-25-2016 01:18 pm

Fuel Stuff > thickness of material for under gas tank (8 replies - 2666 views)

You can use a lot of things under the tank, but just keep in mind "Air flow", should it get wet under there it needs ...   10-02-2016 02:15 pm

Electrical & Instruments > Rear and reverse circuit (8 replies - 3358 views)

Check your grounds, the rear lights are supposed to ground themselves thru the fasteners, doesn't work half the time, best bet is to just run ...   10-02-2016 02:11 pm

Body & interior stuff > Wiper arm removal (13 replies - 3440 views)

If you have the original stainless steel ones there is a small metal tab under the post cap, use a small screw driver to push ...   09-24-2016 01:15 pm

Body & interior stuff > fender gaskets (3 replies - 1692 views)

The non corrosive gasket is there to keep the wing and rccker separate so that any moisture will drain off, having it sealed creates a ...   09-15-2016 01:04 pm

VIN Database for Jensen Healey & Jensen GT > Looking for # 13921 (10 replies - 5777 views)

Have you tried the DMV in CA, maybe they can help you, or one of those search company's that specialize in finding cars for buyers ...   09-11-2016 01:54 pm

Suspension > Changing front wheel bearings (12 replies - 4719 views)

The seal rotates fixed with the bearing hub, a small smear of whatever grease you are packing the bearings with on the lip, and body ...   08-22-2016 12:40 pm

Suspension > Changing front wheel bearings (12 replies - 4719 views)

Put the seal into the hub, and seat it properly, trying to put it on the shaft and getting the seal to sit in the ...   08-21-2016 01:19 pm

Body & interior stuff > 1973 Top Boot AKA parade boot install (1 reply - 1257 views)

The split metal tabs work similar to the convertible top, spread the cover out and then slide the tabs into the chrome hold downs on ...   07-17-2016 01:53 pm

Cooling > Temp Gauge (5 replies - 2276 views)

Sounds like the sender is going bad, time for a change. ...   07-16-2016 01:13 pm

VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (278 replies - 242652 views)

Time, Service bulletin's don't call for a gasket any longer, as long as the oil passage has the O-ring groove in the tower gasket compound ...   06-18-2016 01:10 pm

Cooling > rebuilding the water pump (11 replies - 6229 views)

You can buy the bearing for $13.10 and the seal for $10.80 from JAE and do it yourself, they even have a tool to set ...   06-06-2016 12:53 pm

Engine & Transmission > MK 1 belt tensioner (3 replies - 2151 views)

PM me with your e-mail and I will send you a few pict's. Brett ...   05-31-2016 12:43 pm

Cooling > rebuilding the water pump (11 replies - 6229 views)

Bruce Madden "The red Racer" in GA rebuilds them ...   05-30-2016 12:53 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 4631 views)

bump ...   05-25-2016 12:51 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 8148 views)

If you take another look at the diagram you will see that at the pump it will recirculate back to the tank so that there ...   05-25-2016 12:49 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 8148 views)

There is a fuel flow restrictor on the return to the tank, http://www.deltamotorsports.com/products/pg4d-fuel-system.html item 33 on the diagram. is that in place and if so ...   05-23-2016 12:37 pm

Projects > 18711 "Miss Jensen" (107 replies - 90345 views)

Joachim, just replaced my battery and here in the US the 56 frame works well in a JH. Thanks for the tip on the riveted ...   05-21-2016 01:18 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 8148 views)

Have to agree with Gordon, your running twice the PSI you should be, that can cause issues you probably never thought of, either get a ...   05-21-2016 01:15 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 4631 views)

Getting closer / bump ...   05-17-2016 12:57 pm

Engine & Transmission > Leaking cam seal (15 replies - 4892 views)

Is it the seal or is it coming out the pulley bolt, if it's the bolt, undo it and put some RTV on the threads, ...   05-13-2016 01:02 pm

Engine & Transmission > '75 5 speed Question (9 replies - 3217 views)

I have towed a couple of JH's due to breakdowns with no issue's, and dollied one from another State with the rears down, again no ...   05-09-2016 12:34 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 4631 views)

Okay all of you procrastinators! Jensen East 2016 is now barely 1 month away and the hotel will be releasing our block of rooms on ...   05-07-2016 07:52 pm

Engine & Transmission > Belt idler pulley and bearings. (56 replies - 15592 views)

Frank, Tim did supply the bearing numbers if you want to try over the counter. ...   05-06-2016 12:46 pm

Engine & Transmission > Belt idler pulley and bearings. (56 replies - 15592 views)

Frank, it's a one piece unit and purchased whole, I have one on my JH5, I did cross reference it some time ago and the ...   05-05-2016 12:58 pm

Body & interior stuff > Bodywork rebuild order (3 replies - 1927 views)

The biggest point to set gaps I found was the door shut pillar, the panel next to your shoulder if you were sitting in the ...   05-05-2016 12:52 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 4631 views)

Bump bump bump bump, didn't see it advertised in this months Standard so here is a little reminder, it's a great time and worth the ...   05-04-2016 01:13 pm


 Current time is 10:46 am
 First Page Previous Page  1  2  3  4  5  6  7  ...  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems