| ||||
|
Posts by Brett Gibson JH5 20497 | |
---|---|
798 posts | Showing posts 121-160 of 798 |
Body & interior stuff > Wiper arm removal (13 replies - 16539 views) If you have the original stainless steel ones there is a small metal tab under the post cap, use a small screw driver to push ... 09-24-2016 01:15 pm Body & interior stuff > fender gaskets (3 replies - 6465 views) The non corrosive gasket is there to keep the wing and rccker separate so that any moisture will drain off, having it sealed creates a ... 09-15-2016 01:04 pm VIN Database for Jensen Healey & Jensen GT > Looking for # 13921 (11 replies - 20820 views) Have you tried the DMV in CA, maybe they can help you, or one of those search company's that specialize in finding cars for buyers ... 09-11-2016 01:54 pm Suspension > Changing front wheel bearings (12 replies - 19573 views) The seal rotates fixed with the bearing hub, a small smear of whatever grease you are packing the bearings with on the lip, and body ... 08-22-2016 12:40 pm Suspension > Changing front wheel bearings (12 replies - 19573 views) Put the seal into the hub, and seat it properly, trying to put it on the shaft and getting the seal to sit in the ... 08-21-2016 01:19 pm Body & interior stuff > 1973 Top Boot AKA parade boot install (1 reply - 4867 views) The split metal tabs work similar to the convertible top, spread the cover out and then slide the tabs into the chrome hold downs on ... 07-17-2016 01:53 pm Cooling > Temp Gauge (5 replies - 10570 views) Sounds like the sender is going bad, time for a change. ... 07-16-2016 01:13 pm VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 542945 views) Time, Service bulletin's don't call for a gasket any longer, as long as the oil passage has the O-ring groove in the tower gasket compound ... 06-18-2016 01:10 pm Cooling > rebuilding the water pump (11 replies - 21258 views) You can buy the bearing for $13.10 and the seal for $10.80 from JAE and do it yourself, they even have a tool to set ... 06-06-2016 12:53 pm Engine & Transmission > MK 1 belt tensioner (3 replies - 6825 views) PM me with your e-mail and I will send you a few pict's.
Brett ... 05-31-2016 12:43 pm Cooling > rebuilding the water pump (11 replies - 21258 views) Bruce Madden "The red Racer" in GA rebuilds them ... 05-30-2016 12:53 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) bump ... 05-25-2016 12:51 pm Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32945 views) If you take another look at the diagram you will see that at the pump it will recirculate back to the tank so that there ... 05-25-2016 12:49 pm Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32945 views) There is a fuel flow restrictor on the return to the tank, http://www.deltamotorsports.com/products/pg4d-fuel-system.html item 33 on the diagram. is that in place and if so ... 05-23-2016 12:37 pm Projects > 18711 "Miss Jensen" (129 replies - 247829 views) Joachim, just replaced my battery and here in the US the 56 frame works well in a JH. Thanks for the tip on the riveted ... 05-21-2016 01:18 pm Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32945 views) Have to agree with Gordon, your running twice the PSI you should be, that can cause issues you probably never thought of, either get a ... 05-21-2016 01:15 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Getting closer / bump ... 05-17-2016 12:57 pm Engine & Transmission > Leaking cam seal (20 replies - 26647 views) Is it the seal or is it coming out the pulley bolt, if it's the bolt, undo it and put some RTV on the threads, ... 05-13-2016 01:02 pm Engine & Transmission > '75 5 speed Question (9 replies - 13048 views) I have towed a couple of JH's due to breakdowns with no issue's, and dollied one from another State with the rears down, again no ... 05-09-2016 12:34 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Okay all of you procrastinators! Jensen East 2016 is now barely 1 month away and the hotel will be releasing our block of rooms on ... 05-07-2016 07:52 pm Engine & Transmission > Belt idler pulley and bearings. (56 replies - 82035 views) Frank, Tim did supply the bearing numbers if you want to try over the counter.
... 05-06-2016 12:46 pm Engine & Transmission > Belt idler pulley and bearings. (56 replies - 82035 views) Frank, it's a one piece unit and purchased whole, I have one on my JH5, I did cross reference it some time ago and the ... 05-05-2016 12:58 pm Body & interior stuff > Bodywork rebuild order (3 replies - 6700 views) The biggest point to set gaps I found was the door shut pillar, the panel next to your shoulder if you were sitting in the ... 05-05-2016 12:52 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Bump bump bump bump, didn't see it advertised in this months Standard so here is a little reminder, it's a great time and worth the ... 05-04-2016 01:13 pm Body & interior stuff > Bodywork rebuild order (3 replies - 6700 views) There is no adjustment on the rear fenders, so they went on 1st in my case, followed by the fronts, can't install the fronts if ... 05-04-2016 01:06 pm Engine & Transmission > cams, valve timing and ignition timing (106 replies - 146058 views) my 2 cents.
Double check every thing, set the crank at TDC pull the #1 plug and make sure the piston is at the top as ... 05-01-2016 02:15 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Bump Bump Bump ... 04-14-2016 01:28 pm Miscellaneous > Pete Bahr (10 replies - 10977 views) Frank, talk to Bob Clarke he is in touch with the family last I heard. Brett ... 04-01-2016 01:04 pm Engine & Transmission > Tensioner removal (6 replies - 10151 views) Clinton is right on the money but seeing you haven't done this before or seen apart just what you are dealing with it is a ... 03-27-2016 02:00 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Bump Bump ... 03-22-2016 01:10 pm Body & interior stuff > Help! Seat won't tilt forward, can't tighten track mounts (10 replies - 15912 views) The nuts on my car are welded to the inside of the seat rails and can't be gotten to, if yours are like mine the ... 03-22-2016 01:08 pm Electrical & Instruments > side marker replacement bulbs (6 replies - 11506 views) Sorry for not getting back sooner, I did find and check my pictures a bit blurry but I have a sketch as well, PM me ... 03-20-2016 07:18 pm Electrical & Instruments > side marker replacement bulbs (6 replies - 11506 views) They can be taken apart and cleaned up, but be very slow and careful there are springs inside and they can let fly if you ... 03-16-2016 01:18 pm Electrical & Instruments > side marker replacement bulbs (6 replies - 11506 views) Bulbs or bad ground...... ... 03-11-2016 12:49 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Bump ... 03-10-2016 12:47 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) It's time! Registration is now open for Jensen East 2016 in Syracuse Indiana, June 8-11. You will definitely want to be there! As a teaser, ... 03-02-2016 01:34 pm Electrical & Instruments > Random Blinker (2 replies - 6377 views) Check your column mounted blinker switch to see if it has not released, work it back and forwards & up & down, might just be ... 03-01-2016 12:57 pm Engine & Transmission > Clutch adjustment ? (9 replies - 13347 views) The cable would be the first place to look and hopefully that would be it, next I would make doubly sure that the shifting fork ... 02-28-2016 01:56 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14271 views) Just a heads up, registration coming soon. June 8 thru 11. http://jenseneast.org/2016-syracuse-in.html ... 01-23-2016 01:57 pm Wheels > Wheels again (1 reply - 5825 views) Lug's ... 01-18-2016 01:33 pm | |
Current time is 02:19 pm | 1 2 3 4 5 6 7 8 9 ... |