Home 
Home Search search Menu menu Not logged in - Login | Register
> mtechwim

Profile Topics Posts
Posts by mtechwim
53 postsShowing posts 1-40 of 53

Engine & Transmission > valve cover sealing. (12 replies - 11290 views)

Used the black ones, that was not ok, the bottom one keeps leaking, now i have the green one, after a first test it stays ...   09-19-2021 08:01 pm

Ignition > 123ignition (9 replies - 8404 views)

Engine is running fine now, only over 5000 rpm needs some tuning from fuel or ignition. Cold start with choke is perfect, even after Months ...   09-19-2021 07:52 pm

Body & interior stuff > Bumpers (4 replies - 6513 views)

I did it with a car Polish machine, depending on the polish stuff it Will give a stunning result. I there are a lot of scratches ...   04-30-2021 07:28 pm

Carburetors > Out of tune Stroms causing sputter/rough running? (8 replies - 12989 views)

That would be great ...   04-19-2021 09:57 pm

Body & interior stuff > Replacement hardware for restoration (7 replies - 5531 views)

Not all the fastners orders at robey Will work i found out, i Made my own fastners for the trunk trim. Also not all of ...   03-15-2021 06:49 pm

Engine & Transmission > Hydraulic clutch conversion (2 replies - 3323 views)

Think you need a large travel master cylinder BMW has those, but the are build in the pedalbox. If needed I could look if I have a ...   07-05-2020 02:40 pm

Body & interior stuff > Where do the body panel Data Plates go? (6 replies - 6177 views)

First picture of Dakota, Mine is sitting on the door On the opposite site, and not on the body. Can’t upload the foto. ...   07-05-2020 02:30 pm

VIN Database for Jensen Healey & Jensen GT > New member, 1975 JH (3 replies - 4235 views)

Welcom, Looks great to me, rims fit nice with the car. Also the roof fits nice with the color. ...   06-24-2020 08:10 pm

Body & interior stuff > Steering wheel replacement thoughts (8 replies - 7368 views)

How about some pictures, gives a bit more by your story ...   06-20-2020 03:47 pm

Body & interior stuff > Steering wheel replacement thoughts (8 replies - 7368 views)

If you have long legs, I would chouse a dish wheel, gifs a bit more leg room. ...   06-18-2020 07:36 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

I already opened up the wire loom from the fusebox to the foot compartment, to check if there also issues can be found. The only wire ...   06-11-2020 10:08 am

Projects > 18680 project from Holland (16 replies - 13086 views)

Have to solve some power issues I guess ...   06-08-2020 08:36 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

New view ...   06-07-2020 08:28 am

Projects > 18680 project from Holland (16 replies - 13086 views)

That’s the engine bay when I bought the car 6 months a go. ...   06-06-2020 07:34 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

Some spare parts ...   06-06-2020 07:01 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

Rear ...   06-06-2020 07:00 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

Front ...   06-06-2020 06:59 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

I did putt u short movie of the first start on FB today. Still need some tuning to do, carbs and ignition. Also u bit of fuelpressure ...   06-06-2020 06:50 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

Let’stry to upload some photos ...   06-03-2020 07:26 pm

Ignition > 123ignition (9 replies - 8404 views)

This weekend fixing the carbs, and waiting for the Holley fuelpressure regulator. Than i can try to start the car and see what’s happening. So ...   05-28-2020 08:04 pm

Engine & Transmission > Missing marks on auxiliary pulley?(replacing timing belt) (7 replies - 6894 views)

Yup, no problem taking just the cap off, the cap fits ly one way due to a notch on it. It’s easier when the carbs are ...   05-28-2020 07:12 pm

Engine & Transmission > Missing marks on auxiliary pulley?(replacing timing belt) (7 replies - 6894 views)

One pic with the crank at TDC and the cams not timed up perfectly The belt has now been tensions and the engine has turnd over ...   05-28-2020 07:44 am

Engine & Transmission > Missing marks on auxiliary pulley?(replacing timing belt) (7 replies - 6894 views)

Everything lined up aften mounting the belt. ...   05-28-2020 07:42 am

Engine & Transmission > Missing marks on auxiliary pulley?(replacing timing belt) (7 replies - 6894 views)

The book says that the marking on the aux shaft should point towards the center of the crank bolt. I did it that way, see ...   05-28-2020 07:30 am

Projects > 18680 project from Holland (16 replies - 13086 views)

Almost read with all off the small jobs, -handbrake light - radio - dash lights - air valves at foot space, working now - door seals replaces - door locks set, ...   05-23-2020 07:51 pm

Ignition > 123ignition (9 replies - 8404 views)

I am installing one at the moment, The extra seal is not pressend, but I als read on the Facebook page that they don’t leak. ...   05-18-2020 10:14 pm

Carburetors > fuel leak stromberg (11 replies - 10116 views)

I found out dat also the rubber seals from the throttle axle were shot. So I would advice a full refurbishment of the carbs to. ...   05-15-2020 05:38 pm

Carburetors > fuel leak stromberg (11 replies - 10116 views)

The big kopper one is ideal when you want to replace the jet. ...   05-14-2020 03:47 pm

Carburetors > fuel leak stromberg (11 replies - 10116 views)

The top one, is easy but becarvul, clean outside, spray some tread lube around, wait a bit and with a small screwdriver pull it out. ...   05-14-2020 03:34 pm

Carburetors > fuel leak stromberg (11 replies - 10116 views)

Here is an other model from kopper, no idee what the difference is.this one fare less fragile. If possible I would like to use this ...   05-14-2020 12:45 pm

Carburetors > fuel leak stromberg (11 replies - 10116 views)

Here is are some foto’s ...   05-14-2020 10:12 am

Carburetors > fuel leak stromberg (11 replies - 10116 views)

Do you mean the big plug in the center of the bowl? If so be very careful with it it has plastic parts, I could ...   05-13-2020 10:17 pm

Projects > 1973 Jensen Healey #10777 Lotus "Colin Chapman" Edition "Gold Leaf" Build (45 replies - 41020 views)

That looks super 😁 ...   05-08-2020 05:36 pm

Engine & Transmission > Leaking cam seal (20 replies - 26426 views)

I bought the rubber ones , and I will see what happens ... I’ll make the surface super clean bevor installing the gasket and covers. The cam ...   05-01-2020 08:15 am

Engine & Transmission > Leaking cam seal (20 replies - 26426 views)

Did some investigation today about leaking cam covers. I found out that leaking mainly from the exhaust cam is not very strange. Because the oil return holes ...   04-30-2020 06:48 pm

Engine & Transmission > Lubrication system diagram (25 replies - 22705 views)

Good topic Found out that from my oil pump the outer ring was broken in 2 But a fast replacement from Kees fixed te problem I hope. ...   04-30-2020 04:03 pm

VIN Database for Jensen Healey & Jensen GT > Service Production Record (5 replies - 7083 views)

No I am not they original owner, I got my copy from Martin Robey as a present with a large order spare parts. I try to ...   04-25-2020 06:11 pm

VIN Database for Jensen Healey & Jensen GT > Service Production Record (5 replies - 7083 views)

Here is a copy of mine, also with some strange notes ...   04-25-2020 07:43 am

Projects > 19661 paint and bodywork (64 replies - 64947 views)

That looks awesome dude, have lots of fun with it! ...   04-14-2020 09:01 pm

Projects > 18680 project from Holland (16 replies - 13086 views)

Lots of work done the last weeks - all bushings front and rear - weelbearings front - engine and gear mounts replacement - differential oil - brakes rear - refurbishing front ...   04-12-2020 01:05 pm


 Current time is 12:58 pm
   1  2  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems