OK, so here's a strange one. I went out to start my J-H today and nothing - no click, no starter.  All other electric items (lights, ...   05-26-2006 03:03 am

Mark, Thanks for the suggestions. Besides providing humor for me and my son, it's something I can try fairly easily. As for the manifold-to-engine joint, how ...   09-16-2005 03:12 am

When I purchased my J-H, it had a Delta header that seemed to be in OK condition. No visible holes or rust. Aft ...   09-15-2005 11:37 pm

For all of you who have gone through your front/rear suspensions, do you have any advice on: 1) If you had it to do over, would ...   09-02-2005 03:40 am

Adam, Did you have to remove the belt from the reel in order to remove the new buckle and replace it with the old one? ...   08-25-2005 02:22 am

Mark, you wouldn't happen to have any undercar photos of the exhaust system after installation, would you? I purchased the Delta system recently. I've cut ...   08-05-2005 11:42 pm

You should not need a smog test, as your JH is >30 years old. I registered my 1974 JH in California (San Jose) a ...   08-05-2005 11:36 pm

I'm pretty sure my original seat belts are no longer of any use. I don't think that the belts will lock under any condition. What ...   06-28-2005 05:34 pm

I recently purchased a tonneau from Delta Motorsports. It arrived and appears to be the correct size and of good quality, but it came ...   06-28-2005 05:18 pm

Mark, Was no welding required? I thought that, as delivered, some welding would be required to assemble the system. I'm trying to decide what ...   06-28-2005 04:57 pm

Did you fit the 205/60's on the original wheels? Thanks, Ken ...   06-23-2005 09:27 pm

See- I knew someone would have a clever answer! Putting a wrench on the top nut and then rotating the mount hadn't occurred to ...   06-02-2005 05:16 pm

Last weekend I attempted to replace the engine mounts. I say "attempted" because I only succeeded in replacing the right (intake side) mount. ...   06-02-2005 03:02 pm

Mark, I have a 1974 J-H. If I understand correctly, then, my exhaust cam gear is mounted backward, since it is marked with 110 In ...   05-24-2005 05:16 pm

I'm confused about what I SHOULD be seeing on my cam sprockets. I have a 1974 J-H, and each cam sprocket has two markings: ...   05-24-2005 02:50 pm

I installed the Delta mount the weekend before last, and everything went so smoothly that I couldn't believe it! Many, many thanks, Mark, for ...   05-23-2005 11:00 pm

Mark, Is the transmission mount working OK without being shimmed? I just took my old one off, and I have a new replacement (from Delta). ...   05-14-2005 03:02 am

I put the rear of the car up on jack stands, and this is what I found: 1) The transmission mount is visibly toast. The ...   05-07-2005 01:33 am

My shifter impacts the console when shifted into 2nd. Is that a transmission mount-related issue? How can I tell? ...   05-05-2005 10:23 pm

I have exactly the opposite problem. My turn signals work fine, but the emergency flashers don't work. I'm assuming that I have a ...   04-29-2005 05:52 pm

How high do these struts raise the hood? In the '74 J-H I bought this weekend (from Tim Fultz), someone in the past replaced ...   04-26-2005 11:08 pm