The dash panels are flat. The dash itself is metal with the finished dash material covering it. This gives you some irregular surfaces and angles ...   11-15-2013 03:34 am

While making new wood dash panels a couple years ago, I removed my non working dimmer controll and relocated the choke cable to that location. ...   11-13-2013 04:00 am

I put the Kumho 185's on my JH about three years ago. They have a good ride and feel to them. I don't race but ...   03-21-2013 08:59 pm

I found it easier to remove the drivers seat. With the seat out you can lay on your back and reach under the dash. Still a ...   01-29-2013 02:44 am

Frank is correct. Had mine done locally about two years ago. No problem. If the belt was new and is not damaged it should be ...   11-22-2012 03:21 pm

Just a reminder for everyone. Please try to post your questions, requests for information and discussions under the correct heading from the Forum column at ...   11-07-2011 01:39 am

I also have a Budge cover. It was with the car when I bought it in 2000. It is a simple cloth cover with no ...   08-09-2011 12:14 am

Just bought four of them from Delta for about $22 each. They had them in stock. They are a flat profile instead of the tapered ...   07-09-2011 01:54 am

Delta Motorsports in Phoenix Az. has almost anything you need for your JH. Call them at 602 265 8026 for parts and or advise. Very ...   04-14-2011 01:51 am

My sway bar kit from Delta included two L shaped brackets. Instead of reversing the A-arms, I welded the brackets to the the back side of ...   04-08-2011 12:57 pm

Replaced mine with a one piece shaft about four years ago without any problems. Nice upgrade. No need for a support bearing. I left the cross ...   02-21-2011 01:00 am

As I've said many times, "Great site with great people". Thanks to all. ...   10-26-2010 09:57 pm

Thinking about having a vehicle shipped to me. Looking for suggestions on a good transport company. Let me know who you used and if it was a good ...   07-27-2010 09:04 pm

Hey Greg, just read your story in the club magazine about the Mityvac and the Mini Cooper. Had me laughing out loud. Love it when a plan comes ...   02-22-2010 09:32 pm

I repaired mine by connecting a short piece of 5/16" wide cable tie around the compression ring with three small flat head screws and nuts. I started by sanding ...   09-21-2009 05:51 pm

Hey Kurt, great answer on flipping the car. Why waste a perfectly good roll bar. As always, thanks for the great and helpful information. ...   03-16-2009 10:36 pm

I am looking for a pair of sun visors. My JH didn't have any when I bought it. They don't have to be in great ...   08-30-2007 12:58 am

Vin# 19032 JH 5 speed Engine# B 74 10 9910 Very good condition mechanically. Pretty much stock with a few upgrades. Running strombergs, electronic ignition, three core ...   11-26-2006 05:28 pm

I have to agree with Greg. A professional upholstery job is hard to beat. It also gives you a lot of options to customize your ...   04-23-2006 03:00 am

I bought my JH-5 in the spring of 2000. I had never heard of or seen one untill I came across this one. After checking ...   11-02-2005 01:55 am