Hi Guys, I realise that I am responding to an old post but just wondering if any owners have tried fitting an aftermarket Datsun 240Z ...   02-09-2025 12:36 am

I know this is an old post but personally what I do with my motorcycles when the engines have not been started in a while ...   04-03-2024 04:11 am

Hi Tim, Thank you very much for your reply, you are a wealth of information, I have always learnt a lot from your past posts. My ...   12-03-2015 07:25 pm

Hi Guys, I have trolled all the forum posts and the net and have not been able to find any information on this internal steel ...   11-15-2015 01:13 pm

Hi Randall and anyone else who may be interested in this post. I am not familiar with Desktop Dyna 2000 but read your post with interest ...   05-03-2015 02:01 pm

Hi Barthol,   I will be very interested in hearing how your car goes with the 2.2 conversation.   I too am building a 2.2 with 9.5:1 comp ratio, ...   04-05-2014 07:26 pm

I removed mine very easily and without damaging it using the grease method this youtube link shows the method but infact the video makes it ...   01-15-2012 12:44 pm

We all know that the 907 engine was years before its time, especially for a 1972 production engine. We all strive to make improvements if ...   07-01-2011 12:46 pm

Thanks for your 5 cents worth Dakota123, I’m sure Greg Fletcher mentioned to me that it was OK to fit a front sway bar by ...   04-10-2011 10:48 pm

Hi Ross, Thanks for your prompt reply and good advice, I will check the orientation of the A-arms out when I do the job as I will ...   04-07-2011 11:30 pm

Hi, I have seen that an Addco 101 Front Anti Sway Bar kit is currently listed on eBay for $141. My question are; is this the best ...   04-06-2011 01:34 pm

I am very interseted in the brake ducting modificatiion. Do you or anyone have and photos, drawings or information on how to go about this. ...   03-29-2009 06:18 am