Home 
Home Search search Menu menu Not logged in - Login | Register
> Bob McDonald

Profile Topics Posts
Posts by Bob McDonald
6 postsShowing posts 1-6 of 6

Cooling > Still Running Hot! (17 replies - 34954 views)

Dave-I have had the same problem when I was playing with the ignition curves. If you have run on then make sure your not running over ...   09-19-2008 05:53 pm

Electrical & Instruments > Short in Purple Wire "Ignition Off Wire Hot" Circuit (8 replies - 15803 views)

Hi Lash The wiring diagram shows the purple wire comes from the fuse box and goes to the 9 way connector by the steering column and then ...   06-24-2008 03:03 pm

Engine & Transmission > Clutch Operation (9 replies - 16341 views)

Hi Dan Your set-up looks great. I used the ford throwout bearing with the healey forks so I didn't have to machine transmission and with the unit ...   06-03-2008 05:43 pm

Engine & Transmission > Clutch Operation (9 replies - 16341 views)

Hi Joel I wrote out what I've done and sent it to Greg but I didn't have any photos so it was probably hard to follow and ...   06-02-2008 07:36 pm

Engine & Transmission > Clutch Operation (9 replies - 16341 views)

Dan I have the same setup as you except the throwout bearing is ford and the healey forks pins ground out to fit.That's were the 3 ...   06-02-2008 03:31 pm

Engine & Transmission > Clutch Operation (9 replies - 16341 views)

Hi Dan I found that there are 3 different ford throwout bearings so depending on your set-up you may need the longer one Bob ...   05-30-2008 10:16 pm


 Current time is 01:11 pm
 


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems