74 J-H WAS RUNNING GREAT SINCE VALVE JOB 3 YEARS AGO. ON LAST A.M STARTUP FROM COLD, REVED TO ABOUT 6K- THROTTLE STUCK- I SHUT ...   10-09-2008 01:46 pm

I'M NOT SURE IT,S A CARB PROBLEM, BUT HERE GOES....TIMING BELT LET GO LAST FALL; DID A VALVE JOB OVER THE WINTER- SEEMS TO BE ...   08-23-2007 07:08 pm

TOTAL VALVE JOB RESULTED IN ZERO COMPRESSION ON CYLS1&2, 60 LBS ON 3&4 ALL NEW VALVES, GASKETS, ETC...AM I MISSING SOMETHING OBVIOUS, OR JUST STUPID? BILL ...   04-12-2006 01:53 pm

NOT SURE MY FIRST MESSAGE WENT THROUGH.... D   DID VALVE JOB- NOW HAVE NO COMPRESSION ON ANY CYLINDERS!!ANY SUGGESTIONS, NO MATTER HOW OBVIOUS, WOULD BE MUCH APPRECIATED!    ...   04-09-2006 08:52 pm

TIM THANKS ROR QUICK RESPONSE....PLEASE FORWARD "MENTAL PART" INFO YOU REFERENCED...... ..............BILL             HEIDI-BILL-B@ATT.NET ...   11-11-2005 01:33 pm

THE VALVE JOB IS COMPLETE, BUT BEFORE I REASSEMBLE THE ENGINE, I'D LIKE TO CHECK/ ADJUST THE VALVES....WHAT'S THE BEST WAY TO DO THIS AT ...   11-08-2005 09:02 pm

While waiting for my engine head to come back from the machine shop, due to the dreaded timing belt slippage, I've been looking at and ...   10-22-2005 08:41 pm

BETWEEN THE DRAMATIC LOSS OF COMPRESSION, AND THE STRANGE METTALIC SOUNDS WHEN THE TENSIONER DECIDED TO LOOSEN UP AT 40 MPH,I'M NOW FACED WITH ...   08-31-2005 08:43 pm

THANKS TO MARK R. AND RON E., FOR THE QUICK RESPONSE, THOUGH THEY CONFIRMED MY FEAR OF BENT VALVES. THE SHOP MANUAL GIVES INSTRUCTIONS FOR REPAIR, ...   07-05-2005 05:57 pm

I have been unable to get adequate compression on 2 of the 4 cylinders on my 1974 J.H. This happened after I attempted to change the ...   06-30-2005 11:26 am