| ||||
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Temperature and fuel gauges not working |
| ||||
> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Temperature and fuel gauges not working |
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Temperature and fuel gauges not working | Rate Topic |
| Author | Post |
|---|
| Posted: 08-04-2023 12:34 pm |
|
1st Post |
|
chrisl Member 
|
Hi all The Prince of Darkness reaches out again... In spite of replacing the alternator on my GT, my battery runs flat even after a long run in the countryside at speed. The temperature and fuel gauges also register zero, but the other gauges work. I can't recall where, but recall reading that a possible culprit might the voltage stabiliser. If so, it would be a relatively cheap and easy fix. Anyone else encountered this phenomenon?
|
||||||||||||||
| |||||||||||||||
| Posted: 08-04-2023 03:18 pm |
|
2nd Post |
|
noomg Member
|
chrisl, I'm not sure you can blame the Prince of Darkness might be the Prince of Years of Neglect. First what shape is your battery in and what is the voltmeter reading? Did both gauges fail at the same time? If so the voltage stabilizer replacement is a good option.
|
|||||||||||||
| ||||||||||||||
| Posted: 08-05-2023 12:59 am |
|
3rd Post |
|
redracer Member
|
You are correct in that both the fuel & temp gauge run off the voltage stabilizer, located high uo in the back by the 2 gauges, The GROUND for it is the casing going through a sheet metal screw to the metal gauge panel back, which gets oxidized easily. Highly recommend gthe MOSS one which is solid state for the 10 volt output. As for the alternator, don't forget the light for the IGNITION , located in the bottom center of your center console panel, must be working! Keep us posted. bruce
|
||||||||||||||
| |||||||||||||||
| Posted: 08-05-2023 01:01 pm |
|
4th Post |
|
chrisl Member
|
Thanks all For a car that is almost half a century old, it runs extremely well. The voltage gauge did hover around 11 - 12v; typically it was around 14 - 15v. The battery and alternator are almost brand new and I've had no problems with these two gauges until now. They failed at the same time which made me think that it must be a component that they share. I'll order a new voltage stabiliser, and give the connections a good clean. I didn't know about the 'ignition' light; will check it tomorrow. Thanks again, watch this space.
|
|||||||||||||
| ||||||||||||||
| Posted: 08-05-2023 09:49 pm |
|
5th Post |
|
healeyneil Member
|
Doesn’t help, but I have an odd problem. My charging system works fine according to the volt meter, but my ignition light doesn’t work. No it’s not the bulb !
|
||||||||||||||
| |||||||||||||||
| Current time is 06:43 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Temperature and fuel gauges not working | Top |
