Temperature and fuel gauges not working - Electrical & Instruments

> Jensen Healey & Jensen GT Tech > Electrical & Instruments > Temperature and fuel gauges not working

Author

Post

chrisl
Member

Joined:	09-21-2006
Location:	Perth, Australia
Posts:	110
Status:	Offline

Hi all

The Prince of Darkness reaches out again...

In spite of replacing the alternator on my GT, my battery runs flat even after a long run in the countryside at speed.

The temperature and fuel gauges also register zero, but the other gauges work.

I can't recall where, but recall reading that a possible culprit might the voltage stabiliser. If so, it would be a relatively cheap and easy fix.

Anyone else encountered this phenomenon?

noomg
Member

Joined:	08-02-2018
Location:	Long Beach, California USA
Posts:	428
Status:	Offline

chrisl,

I'm not sure you can blame the Prince of Darkness might be the Prince of Years of Neglect.

First what shape is your battery in and what is the voltmeter reading? Did both gauges fail at the same time? If so the voltage stabilizer replacement is a good option.

redracer
Member

Joined:	09-10-2012
Location:	BROOKHAVEN, Georgia USA
Posts:	628
Status:	Offline

You are correct in that both the fuel & temp gauge run off the voltage stabilizer, located high uo in the back by the 2 gauges, The GROUND for it is the casing going through a sheet metal screw to the metal gauge panel back, which gets oxidized easily. Highly recommend gthe MOSS one which is solid state for the 10 volt output.
As for the alternator, don't forget the light for the IGNITION , located in the bottom center of your center console panel, must be working!
Keep us posted.
bruce

chrisl
Member

Joined:	09-21-2006
Location:	Perth, Australia
Posts:	110
Status:	Offline

Thanks all

For a car that is almost half a century old, it runs extremely well.

The voltage gauge did hover around 11 - 12v; typically it was around 14 - 15v.

The battery and alternator are almost brand new and I've had no problems with these two gauges until now. They failed at the same time which made me think that it must be a component that they share.

I'll order a new voltage stabiliser, and give the connections a good clean.

I didn't know about the 'ignition' light; will check it tomorrow.

Thanks again, watch this space.

healeyneil
Member

Joined:	11-29-2006
Location:
Posts:	11
Status:	Offline

Doesn’t help, but I have an odd problem. My charging system works fine according to the volt meter, but my ignition light doesn’t work. No it’s not the bulb !