Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Clutch Throwout-Bearing Pivot

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Clutch Throwout-Bearing Pivot  Rate Topic 
AuthorPost
 Posted: 01-25-2012 06:55 pm
  PM Quote Reply
1st Post
Paul Koehler
Member


Joined: 04-06-2005
Location: Malone, New York USA
Posts: 94
Status: 
Offline
Do the 4 speed and 5 speed transmissions both use the same throwout-bearing pivot?

Attachment: JH clutch throwout bearing pivot.jpg (Downloaded 121 times)

Back To Top PM Quote Reply  

 Posted: 02-09-2012 06:54 pm
  PM Quote Reply
2nd Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Hi Paul,

I measured the 5 speed pivot from the inside of the bellhousing to the top of the ball on the pivot at 2.050". Perhaps a machinist could modify your 4 speed pivot to fit if needed.

Kurt

Back To Top PM Quote Reply

 Posted: 02-09-2012 07:32 pm
  PM Quote Reply
3rd Post
Paul Koehler
Member


Joined: 04-06-2005
Location: Malone, New York USA
Posts: 94
Status: 
Offline
Thanks Kurt-that is exactly the info I needed to modify the 4 speed pivot

 

Back To Top PM Quote Reply  

 Posted: 02-09-2012 09:04 pm
  PM Quote Reply
4th Post
Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 983
Status: 
Offline
Sorry it took so long Paul. Are the rest of the parts the same for either trans? Release lever, throwout bearing etc?

Kurt

Back To Top PM Quote Reply

 Posted: 02-10-2012 04:23 am
  PM Quote Reply
5th Post
Paul Koehler
Member


Joined: 04-06-2005
Location: Malone, New York USA
Posts: 94
Status: 
Offline
The release lever appears to be the same; the throwout bearing is different. I have not seen it yet - it is on order and you have to make a choice of either 4 or 5 speed speedo cable, so I guess that is different. Bell housing is unique to the Getrag unit, but the clutch, pressure plate and pilot bearing can be used in either set-up. Also, as has been mention in earlier discourses, the tranny mount is different and in another location. PK

Back To Top PM Quote Reply  

Current time is 04:02 pm  
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Clutch Throwout-Bearing Pivot Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems