View single post by Greg Fletcher
 Posted: 10-25-2008 02:48 pm
PM Quote Reply Full Topic
Greg Fletcher



Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 430
Status: 
Offline
There's a diagram on page A14 of the Parts Catalogue Supplement, I'll fax over a copy. It's basically a shaft with a rotor that rides in the housing. The key to keeping all this together are the front and rear circlips on the shaft. If these fail or loose enough tension, then everything will go south very quickly. There is no thrust washer in the assembly. The only adjustment is by changing the body to housing gasket, or by actually filing the housing slightly to compensate for high mileage.