View single post by Jim Collins
 Posted: 02-22-2007 08:28 pm
PM Quote Reply Full Topic
Jim Collins

 

Joined: 10-05-2005
Location: Montgomery, Al
Posts: 3
Status: 
Offline
 After rebuilding both calipers up front, drivers side bled quickly, but right side wont.  We were able to remove the line by the pressure differential warning actuator and 'reverse' vacuum, in case there was blockage, and it was clear.  When reattaching the line and going back to the right caliper, we were not successful.  Could this be a bad actuator?  What else could be the problem?  We tried both a vacuum bleeder and just pumping the pedal.  In both cases, air was coming through, but after 10 minutes, no fluid.

Thanks for any help,

Jim

'73 JH, 11749