View single post by answerman
 Posted: 11-12-2013 09:28 pm
PM Quote Reply Full Topic
answerman

 

Joined: 09-10-2012
Location: Little Chute, Wisconsin USA
Posts: 435
Status: 
Offline
Just for what it's worth, I have removed my center console veneer a few times (when replacing the radio and choke cable). I have an early 1974 with the fake wood veneer, so maybe this may be different, but I didn't have to remove the heater knobs. I was able to set the two sliders toward the center of the slot, but not be right on top of each other (let's say the slot is 4 inches wide, so put the top one at about 1 1/2 inches from the left and the bottom one 1 1/2 inches from the right) and they flex enough that you can push the top one down and the bottom one up to sneak them through the slot.