View single post by Brett Gibson JH5 20497
 Posted: 02-04-2011 05:14 pm
PM Quote Reply Full Topic
Brett Gibson JH5 20497


Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 736

The stone guards were not caulked, they did have a coating of rust proof as with the inner fender, at least on the cars I have. Rocker does have a hole in the front inner fender area as well to allow drainage, fender was seam sealed at top along engine compartment and against door hinge were it attaches but not along bottom between the lower fender and sill, it should have a 8 to 10" long X16" thick X 1/2 to 3/4 wide plastic strip as a gasket to seperate the two but not to seal.


Last edited on 02-04-2011 05:17 pm by Brett Gibson JH5 20497