View single post by discogodfather
 Posted: 05-01-2020 01:56 pm
PM Quote Reply Full Topic
discogodfather



Joined: 09-17-2007
Location: San Francisco, California USA
Posts: 202
Status: 
Offline
I did, thanks Brett. Used the ARP nuts to tighten to 27ft lbs which seemed just about right. They all sit at around 1mm difference in height, most of them a little less.

I chased the threads with the ARP tool- good idea because there was alot of crud in there. I cleaned and blew out the rest of the garbage.

They threaded in ok, a little stiff at times. I can see why Tim recommended torqueing them, if you just go hand tight your no where near the bottom in most. They get really tight and you feel like your done turning it with your hand, then notice they are 3/4" height difference.

They really are a work of art, just so crazy expensive.