Home 
Home Search search Menu menu Not logged in - Login | Register
> Brett Gibson JH5 20497

Profile Topics Posts
Posts by Brett Gibson JH5 20497
798 postsShowing posts 121-160 of 798

Body & interior stuff > Wiper arm removal (13 replies - 16425 views)

If you have the original stainless steel ones there is a small metal tab under the post cap, use a small screw driver to push ...   09-24-2016 01:15 pm

Body & interior stuff > fender gaskets (3 replies - 6430 views)

The non corrosive gasket is there to keep the wing and rccker separate so that any moisture will drain off, having it sealed creates a ...   09-15-2016 01:04 pm

VIN Database for Jensen Healey & Jensen GT > Looking for # 13921 (11 replies - 20614 views)

Have you tried the DMV in CA, maybe they can help you, or one of those search company's that specialize in finding cars for buyers ...   09-11-2016 01:54 pm

Suspension > Changing front wheel bearings (12 replies - 19379 views)

The seal rotates fixed with the bearing hub, a small smear of whatever grease you are packing the bearings with on the lip, and body ...   08-22-2016 12:40 pm

Suspension > Changing front wheel bearings (12 replies - 19379 views)

Put the seal into the hub, and seat it properly, trying to put it on the shaft and getting the seal to sit in the ...   08-21-2016 01:19 pm

Body & interior stuff > 1973 Top Boot AKA parade boot install (1 reply - 4834 views)

The split metal tabs work similar to the convertible top, spread the cover out and then slide the tabs into the chrome hold downs on ...   07-17-2016 01:53 pm

Cooling > Temp Gauge (5 replies - 10451 views)

Sounds like the sender is going bad, time for a change. ...   07-16-2016 01:13 pm

VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 538519 views)

Time, Service bulletin's don't call for a gasket any longer, as long as the oil passage has the O-ring groove in the tower gasket compound ...   06-18-2016 01:10 pm

Cooling > rebuilding the water pump (11 replies - 21076 views)

You can buy the bearing for $13.10 and the seal for $10.80 from JAE and do it yourself, they even have a tool to set ...   06-06-2016 12:53 pm

Engine & Transmission > MK 1 belt tensioner (3 replies - 6777 views)

PM me with your e-mail and I will send you a few pict's. Brett ...   05-31-2016 12:43 pm

Cooling > rebuilding the water pump (11 replies - 21076 views)

Bruce Madden "The red Racer" in GA rebuilds them ...   05-30-2016 12:53 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

bump ...   05-25-2016 12:51 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32504 views)

If you take another look at the diagram you will see that at the pump it will recirculate back to the tank so that there ...   05-25-2016 12:49 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32504 views)

There is a fuel flow restrictor on the return to the tank, http://www.deltamotorsports.com/products/pg4d-fuel-system.html item 33 on the diagram. is that in place and if so ...   05-23-2016 12:37 pm

Projects > 18711 "Miss Jensen" (129 replies - 245960 views)

Joachim, just replaced my battery and here in the US the 56 frame works well in a JH. Thanks for the tip on the riveted ...   05-21-2016 01:18 pm

Fuel Stuff > Carbs or Fuel Pump Issues - 2.2L Stroker (20 replies - 32504 views)

Have to agree with Gordon, your running twice the PSI you should be, that can cause issues you probably never thought of, either get a ...   05-21-2016 01:15 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Getting closer / bump ...   05-17-2016 12:57 pm

Engine & Transmission > Leaking cam seal (20 replies - 26417 views)

Is it the seal or is it coming out the pulley bolt, if it's the bolt, undo it and put some RTV on the threads, ...   05-13-2016 01:02 pm

Engine & Transmission > '75 5 speed Question (9 replies - 12945 views)

I have towed a couple of JH's due to breakdowns with no issue's, and dollied one from another State with the rears down, again no ...   05-09-2016 12:34 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Okay all of you procrastinators! Jensen East 2016 is now barely 1 month away and the hotel will be releasing our block of rooms on ...   05-07-2016 07:52 pm

Engine & Transmission > Belt idler pulley and bearings. (56 replies - 81594 views)

Frank, Tim did supply the bearing numbers if you want to try over the counter. ...   05-06-2016 12:46 pm

Engine & Transmission > Belt idler pulley and bearings. (56 replies - 81594 views)

Frank, it's a one piece unit and purchased whole, I have one on my JH5, I did cross reference it some time ago and the ...   05-05-2016 12:58 pm

Body & interior stuff > Bodywork rebuild order (3 replies - 6651 views)

The biggest point to set gaps I found was the door shut pillar, the panel next to your shoulder if you were sitting in the ...   05-05-2016 12:52 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Bump bump bump bump, didn't see it advertised in this months Standard so here is a little reminder, it's a great time and worth the ...   05-04-2016 01:13 pm

Body & interior stuff > Bodywork rebuild order (3 replies - 6651 views)

There is no adjustment on the rear fenders, so they went on 1st in my case, followed by the fronts, can't install the fronts if ...   05-04-2016 01:06 pm

Engine & Transmission > cams, valve timing and ignition timing (106 replies - 145202 views)

my 2 cents. Double check every thing, set the crank at TDC pull the #1 plug and make sure the piston is at the top as ...   05-01-2016 02:15 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Bump Bump Bump ...   04-14-2016 01:28 pm

Miscellaneous > Pete Bahr (10 replies - 10757 views)

Frank, talk to Bob Clarke he is in touch with the family last I heard. Brett ...   04-01-2016 01:04 pm

Engine & Transmission > Tensioner removal (6 replies - 10098 views)

Clinton is right on the money but seeing you haven't done this before or seen apart just what you are dealing with it is a ...   03-27-2016 02:00 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Bump Bump ...   03-22-2016 01:10 pm

Body & interior stuff > Help! Seat won't tilt forward, can't tighten track mounts (10 replies - 15811 views)

The nuts on my car are welded to the inside of the seat rails and can't be gotten to, if yours are like mine the ...   03-22-2016 01:08 pm

Electrical & Instruments > side marker replacement bulbs (6 replies - 11439 views)

Sorry for not getting back sooner, I did find and check my pictures a bit blurry but I have a sketch as well, PM me ...   03-20-2016 07:18 pm

Electrical & Instruments > side marker replacement bulbs (6 replies - 11439 views)

They can be taken apart and cleaned up, but be very slow and careful there are springs inside and they can let fly if you ...   03-16-2016 01:18 pm

Electrical & Instruments > side marker replacement bulbs (6 replies - 11439 views)

Bulbs or bad ground...... ...   03-11-2016 12:49 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Bump ...   03-10-2016 12:47 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

It's time! Registration is now open for Jensen East 2016 in Syracuse Indiana, June 8-11. You will definitely want to be there! As a teaser, ...   03-02-2016 01:34 pm

Electrical & Instruments > Random Blinker (2 replies - 6340 views)

Check your column mounted blinker switch to see if it has not released, work it back and forwards & up & down, might just be ...   03-01-2016 12:57 pm

Engine & Transmission > Clutch adjustment ? (9 replies - 13242 views)

The cable would be the first place to look and hopefully that would be it, next I would make doubly sure that the shifting fork ...   02-28-2016 01:56 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 14185 views)

Just a heads up, registration coming soon. June 8 thru 11. http://jenseneast.org/2016-syracuse-in.html ...   01-23-2016 01:57 pm

Wheels > Wheels again (1 reply - 5773 views)

Lug's ...   01-18-2016 01:33 pm


 Current time is 12:21 pm
 First Page Previous Page  1  2  3  4  5  6  7  8  9  ...  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems