| ||||
|
Posts by Brett Gibson JH5 20497 | |
---|---|
798 posts | Showing posts 721-760 of 798 |
Suspension > Steering column bushing at firewall (5 replies - 13922 views) Bill, the new bushing should have two little numbs on it that fit into holes close to the end of the column tube that the ... 01-11-2006 02:56 pm Suspension > REAR WHEEL BEARINGS - Questions??? (17 replies - 29111 views) Norm, what is the bearing number and brand marked on your new and old bearings, I wouldn't mind trying to match them up at a ... 12-19-2005 02:59 pm Engine & Transmission > Loss of Power/Oil pressure when hot (15 replies - 32474 views) Joel, what wieght oil are you using, from my experience JH's like 20-50, and some loss at temp. is expected, 50 at idle is pretty ... 12-13-2005 11:33 am Miscellaneous > 2006 Nationals Info (3 replies - 10197 views) More info
Greetings Jensen Enthusiasts -
Plans are coming together for next summer's gathering. The event will be in
Springfield, Illinois from June 7th to 10th, 2006.
We ... 12-12-2005 04:46 pm Miscellaneous > Engine on the subframe (7 replies - 13218 views) Erik, truly a thing of beauty, you should be proud of all you have done..............
One concern and I'm uncertain about the fact's, but your brake ... 12-12-2005 04:38 pm Cooling > Overheating (39 replies - 80014 views) Rory, getting back to your flattened hose when cold, it should'nt do that, so why is it, maybe the system becomes under vacumn, like when ... 11-11-2005 06:10 pm Miscellaneous > 2006 Nationals Info (3 replies - 10197 views) John, I believe all who were there for the 2005 Philly Funkhana would attest that you can be bought, it was that raising your pants ... 11-08-2005 11:26 am Miscellaneous > 2006 Nationals Info (3 replies - 10197 views) Just recieved this note, so mark your calanders people................
The plans for the Jensen Nationals East are starting to come together. As
was stated last year, ... 11-03-2005 01:54 pm Carburetors > DHLA 40 vs. 45 (26 replies - 97058 views) And before the Idle Circuit or Main Circuit can establish a fuel flow and take over, the shot-gush will be flushed out and the engine ... 11-03-2005 01:50 pm Carburetors > DHLA 40 vs. 45 (26 replies - 97058 views) My neurons are exploding!!!! gotta agree with Judson on that.
Thanks for all the info Tim, it helps clear up some issue's for me, as for ... 11-03-2005 10:22 am Carburetors > DHLA 40 vs. 45 (26 replies - 97058 views) Tim, how do you know which spec Dell's you have, mine are 40'E's, on a stock engine, would it show on the Dell tags, the ... 11-01-2005 04:54 pm Miscellaneous > Embroiderd JHPS Patch (1 reply - 7006 views) Well, Greg's done it again, just recieved this months Standard and there inside was the two embroiderd patch's I ordered when I renewed my membership, ... 10-18-2005 03:03 pm Engine & Transmission > Motor Dies - will this never end? (19 replies - 30962 views) Sounds electrical to me, ( but always good to run with clean filters), have you checked your battery and ground connections, you may have power ... 10-12-2005 03:58 pm Electrical & Instruments > 14 guage black / white wire? (5 replies - 13077 views) Steve, check this site for a copy of your wiring diagram
http://www.joc.org.uk/wiring.htm
Brett.
... 10-12-2005 03:47 pm Electrical & Instruments > Side Marker Lights (7 replies - 16905 views) Larry, If you have trouble there is a guy in NY state that sell's Brit stuff, he has a scrap yard full of LBC's and ... 10-07-2005 01:15 pm Accessories > Speedometer (1 reply - 12132 views) Check that the cable is running a smooth path to the speedo, make sure that it is fully enganged into the back of the speedo ... 10-04-2005 02:49 pm Ignition > Ballast Resistor? (29 replies - 74910 views) Joel, I think most people on this list at one time or another have shared your experience of wanting to throw the towel in due ... 09-23-2005 04:53 pm Ignition > Ballast Resistor? (29 replies - 74910 views) Have you checked to see if you may have crossed the positive and negative wires on the coil, that will give you problems like these......
Brett
... 09-23-2005 02:32 pm Miscellaneous > Any Jensen Healey Owners in Sacramento CA? (4 replies - 10192 views) "Run out of things to fix" good one Mark ... 09-22-2005 01:34 pm Engine & Transmission > starting (5 replies - 11475 views) Before you muck with the carb's the first thing you should do is make sure the ignition system is working fine, timing, plugs, wires, coil, ... 09-22-2005 01:30 pm Carburetors > Dellorto K&N Filters??? (6 replies - 15077 views) What’s the recommended velocity stack height for a stock JH engine with Dell 40’s
Thanks. Brett
... 09-20-2005 01:02 pm Brakes > Brake Fade (8 replies - 19352 views) Sound's like they still have some air in the system, have you tried a vacumm pump to bleed them, pulling the fluid thru the bleeders ... 09-15-2005 11:47 am Carburetors > strombergs vs dellortos and the tranny (5 replies - 13437 views) If the Dell's are jetted correctly I would go with them, after all the Euro JH's were fitted with them for 4 speeds, if you ... 09-15-2005 11:39 am Miscellaneous > Jensen Healey, Jensen GT air conditioning units (2 replies - 9046 views) And dont forget that double pulley off the crank, GT's and JH's with the pollution plumbing have them, you could mount the compressor were the ... 09-01-2005 01:37 pm Ignition > A distribution of distributor problems (17 replies - 30446 views) Joel, dont sweat it, I broke probably the same thing you did on my distributor and I have been using it for the last 2 ... 08-31-2005 01:23 pm Body & interior stuff > Stock Floor Mats (8 replies - 15689 views) The Delta floor MATS that I purchased after getting the carpet kit turned out to be the same exact thing as the carpet kit minus ... 08-24-2005 11:42 am Engine & Transmission > Oil leak around cam covers (3 replies - 8660 views) Ed, if your using the rubber gasket's on occasion they are know to sqeeze out from under the covers and allow an oil leak, your ... 08-22-2005 06:03 pm Suspension > Rear Wheel Bearing # ??? (1 reply - 7468 views) Anybody have an idea what the SKF / Timken bearing number is for the rear wheel hub ??? that would be just inboard of the ... 08-18-2005 06:06 pm Suspension > Front Wheel Bearing Numbers ??? (3 replies - 16551 views) Thanks for the info Mark.
Still could'nt pull up the individual bearings as per SKF or Timken bearing numbers, so I pulled my front hub off ... 08-18-2005 11:57 am Suspension > Front Wheel Bearing Numbers ??? (3 replies - 16551 views) Does anyone have the bearing numbers for the front wheel bearings, the SKF numbers I had come up as NG. ( LM 11748 outer & L44848 inner ) , ... 08-17-2005 02:24 pm Ignition > Stalling out at high speed (5 replies - 12909 views) RC, I ran into a similar problem after I put my Strombergs back onto my car this year, at high speed there seem's to be ... 08-08-2005 01:14 pm Ignition > Timing and ignition - maybe (23 replies - 24779 views) Andrew, if your at TDC on the crank pully and the cam marks lign up you should be firing on the #1 spark plug, anything ... 08-02-2005 05:57 pm Ignition > Timing and ignition - maybe (23 replies - 24779 views) Andrew, listen to Mark, do not turn that crank shaft with the belt lose, line your crank timing mark up, make sure the cam marks ... 08-02-2005 04:35 pm Cooling > Cooling (5 replies - 14173 views) Arvin, did you get my E-mail on the spoiler ??? and what happened to you radiator that you need a new one cant you just ... 08-01-2005 02:39 pm Engine & Transmission > Cam belt tension/ tensioner (12 replies - 21302 views) I have to agree with Mark, the belt should not whine, even though it is a very important belt and most people would assume tighter ... 07-28-2005 10:59 am Ignition > A distribution of distributor problems (17 replies - 30446 views) George, just a idle thought, the dizzy is alumiun and the clamping bracket steel is it possible just to file away the weld and release ... 07-25-2005 02:56 pm Engine & Transmission > Tranny in the tunnel (13 replies - 24107 views) Ron, your correct the second pict top mount is for the 5 speed, I'll measure off the distance to the studs on my car from ... 07-22-2005 05:58 pm Engine & Transmission > Tranny in the tunnel (13 replies - 24107 views) Hey Ron, I have'nt been under my car for a couple month's but if I remember right the 5 speed tranny is off to the ... 07-22-2005 05:14 pm Engine & Transmission > Fresh Air Intake (8 replies - 14706 views) Judson, my JH 20497 came thru that way and at the Nashville show Bruce did comment on it when he saw it, of course mine ... 07-21-2005 02:33 pm Engine & Transmission > Fresh Air Intake (8 replies - 14706 views) Hey Ron, my JH5 20497 came thru with a GT air box from the factory, the PO tossed it when he put those chrome thingies ... 07-21-2005 11:56 am | |
Current time is 11:57 am | ... 14 15 16 17 18 19 20 |