This is the later version of Delta's header, really has a nice free flow. http://www.deltamotorsports.com/products/pg15d-jensen-healey-headers.html ...   07-26-2019 12:49 pm

Parking brake switch is under the car directly at the hand brake lever, it's a simple switch that most times just goes out of adjustment, ...   07-17-2019 12:50 pm

If the differential is over filled it will leak out at each axle until it finds it's level, The diff. oil should be filled to ...   06-16-2019 01:51 pm

here is a diagram of the carpet lay out. Brett. http://www.deltamotorsports.com/products/pg10b-deltas-carpet-kits.html ...   06-06-2019 01:12 pm

Frank, this is the one I use, probably less expensive ones out there. Brett. https://www.mcmaster.com/belt-tension-gauges ...   05-27-2019 12:45 pm

No, wire issue, you don't have a hot wire going to the ignition system after start and in the run position, had the same issue ...   05-19-2019 02:29 pm

Fuel pressure Way Way high, should be 2.5 to 3.0 max. compression low, did you open the carbs "barrel" so the engine could breath when ...   05-19-2019 02:02 pm

Actually since you’re attached front and back the top is pretty secure, the side attachments just add that additional comfort level. Be aware the rear ...   01-01-2019 08:43 pm

I tried to buy in and was told no longer available, plus there on line pricing is 10 years old. Brett ...   12-24-2018 01:03 pm

Delta has a set for both interior and boot, but Mac. also use the "J" emblem on the carpet mats for driver and Pass. it's ...   12-20-2018 01:20 pm

Bad condenser on the points, spend the money you were going to pay the mechanic and buy the electronic ignition. Brett. PS: even new condensers can be ...   12-15-2018 01:40 pm

Standard 5/8" heater hose supplied by most auto outlets, the factory one had a bend near the fire wall, looks nice and a bit cleaner ...   12-08-2018 01:18 pm

https://www.ebay.com/itm/JENSEN-HEALEY-FACTORY-JACK-AND-HANDLE-SPARE-TIRE-CAR-TOOL/201982258164?hash=item2f0714abf4:g:yAQAAOSwWdZZYp5w:rk:59:pf:0&LH_ItemCondition=4 the true color is blue, this one seems to have been painted, also no bracket that holds it, just a strap. Brett ...   12-01-2018 02:04 pm

In my opinion the SU solid state pump would be the best, not cheap though. Or you can go down to the local auto parts ...   12-01-2018 01:58 pm

Franks correct, you either have the trans not in the right spot or the consul itself. No way did the factory design a car that ...   11-26-2018 01:20 pm

I’m not very good at posting my photos here, but if you PM me I will send you one. ...   11-18-2018 11:56 pm

It mounts to the front battery clamping bracket, there should be, or once was a circular clamp welded onto to it, that the cannister was ...   11-18-2018 01:58 pm

My JH5 had that heat shield as well, the car was one of the last JH's to leave the factory and had a number of ...   10-27-2018 01:45 pm

do a search, question has been answered numerous times, with photo's. ...   10-17-2018 01:36 pm

Stop looking at the carbs, and make doubly sure you’re ignition system is not the issue. ...   10-06-2018 08:16 pm

The gas supply line coming from the tank into the engine bay, the line supplies both Dell's, put it inline BEFORE both, add more hose ...   10-06-2018 03:56 pm

3/8" verses 5/16" not a issue, that speaks of volume of gas delivered, not pressure. pressure can be tested by putting a tee in the ...   10-06-2018 01:47 pm

Ignition system always verify before attempting to play with the carbs, Tim's correct that you should also do the easy stuff on the carbs as ...   07-21-2018 01:25 pm

Delta or the JHPS store / warehouse http://dev.jhps.com/mm5/merchant.mvc?Screen=CTGY&Store_Code=jhps&Category_Code=SUS ...   07-20-2018 12:50 pm

Frank, It depends on what length velocity stack's you have on the carbs. If you visit the web site they list the 1-1/2" for shorter ...   07-08-2018 02:10 pm

Frank, yes these air filters are for both the Dell's and Weber's, you need to know the length of the velocity stacks on your carb's ...   07-04-2018 01:02 pm

Oops, Bruce is correct these air cleaners are for Dellorto’s. not Strom’s. Sorry about that. Brett ...   07-03-2018 08:38 pm

http://www.cbperformance.com/product-p/3378.htm try this site, in my opinion they are a much nicer and robust filter assembly than a K&N. Brett ...   07-03-2018 12:40 pm

First off don't expect to much from the fan, it's two speeds, slow and slower. Next the heater valve is midway along the frame rail ...   06-25-2018 12:58 pm

If your on Face Book, put a post up in Jensen-Healey wanting a good used one, I'm sure someone in that group or even here ...   05-31-2018 04:07 pm

could be the end bearing housing at the steering wheel as well, does it drop a little when you pull it towards you, my shaft ...   05-30-2018 01:24 pm

Sound to me that the honey comb metal webbing that surrounds the central shaft has been compressed. ...   05-30-2018 12:56 pm

Excellent, be seeing you soon. ...   05-22-2018 01:07 pm

First I have heard about this , the usual “rule” has been the more the merrier. Well just checked and looks like some of the activity ...   05-21-2018 08:53 pm

http://www.jenseneast.org/index.html their phone numbers are linked to this site. Kathy's e-mail, kmc@chesnet.net Don's 1973jensenhealey@chesnet.net Looking forward to you visiting us. Cheers Brett. ...   05-12-2018 02:00 pm

bump ...   05-12-2018 01:16 pm

Your missing the passenger side vent flap, it's a duplicate of the drivers side, and should have the little push and pull rod against the ...   05-06-2018 01:44 pm

Bump ...   05-02-2018 12:49 pm

Here is the day to day event schedule for Jensen East 2018 2018 Jensen East Black Mountain Itinerary Wednesday 6/06 • Arrive and Check-in ...   04-18-2018 07:47 pm

I saw the itinerary posted someplace once, but now can't find it..... ? Oops found it, it came as an e-Mail, here you go. ...   04-14-2018 04:21 pm