No its not hitting the Liners, I can see where it has hit the head. ...   11-13-2006 06:07 am

I run a 2.2 910 Block with all the mods. And JE Pistons +30. I had the engine rebuilt, (In Malaysia,) by a good machine ...   11-13-2006 02:35 am

Greg, can I make a comment, I think the JHPS is the bst site I've found for the 900, hence my membership, I don't have ...   11-10-2006 05:23 am

If you reuse the ing gear, I'd try to find a way to mechanicaly lock the ring to the fly wheel, I reused my ring ...   11-08-2006 05:42 am

Dan I'd bet the one's in the shop can be ten years old, and If you've stored it at least you know haw it was done. But ...   11-07-2006 07:14 am

Dan Did I read earlier tha that you are using a Sunbeam 911 Crank? If so be carefull as I wrote on another post the 911 ...   11-07-2006 02:18 am

Dan I run a manual belt adjustor off an early  910 turbo, (Ok but the gauge to check the tension is expensive) on my late 910 ...   11-07-2006 02:09 am

Dan My engine was modified by Garry, very well travelled block, made in England, bought in the USA, modified in England and now raced in Malaysia. Any ...   10-30-2006 05:10 am

Can't put the plate in the centre of the bearing line as my block has the +15 main bore, so re-line boaring would be difficult, ...   09-25-2006 01:03 am

Here's somting you may be interested in. Last year at the Moto GP event in Sepang I ws introduced to a few 'old hands" from Lotus, ...   09-25-2006 12:58 am

Dear Judson and Ron I can't run a dry sump no room under the bonnet, my car is built around a space frame designed for a ...   09-22-2006 03:43 am

Dear Judson Linners wee supplied by Gary Kemp to fit the block. Re failers, I run a Sylva Phoenix with an all up weight of 600kg ...   09-22-2006 12:50 am

I want to buld a top deck plate for a 910 Engine and a lower cradle for the bottom of the bearing ladder. But can't ...   09-20-2006 07:53 am

Just joined the JHPS, but I have run a Sunbeam Lotus Engine for some years. Be very carefull using a Sunbeam 911 crank in a ...   09-15-2006 01:26 am