Home 
Home Search search Menu menu Not logged in - Login | Register
> Art DeKneef

Profile Topics Posts
Posts by Art DeKneef
299 postsShowing posts 81-120 of 299

Suspension > Installing front sway bar (33 replies - 22078 views)

atgparker, I noticed in your picture that the sway bar is attached above the tabs instead of underneath. All the other cars I have seen equipped ...   10-24-2013 08:44 pm

Engine & Transmission > Engine Removal (7 replies - 4855 views)

Having pulled the engine both ways my preferred method is raising the front of the car and removing the engine and trans as a whole ...   10-16-2013 05:44 pm

Suspension > Fitting rear Superpro bushes (27 replies - 16071 views)

They should be available second hand. I'm not sure about availability over there though. Delta might have some. I think the problem would be shipping ...   09-29-2013 03:11 am

Wheels > Stock wheel offset (19 replies - 12688 views)

Well, I got under the car and the rims are marked "ET 15". Hope that helps. Art ...   09-04-2013 01:45 am

Wheels > Stock wheel offset (19 replies - 12688 views)

Do not measure with the tire. Measure the rim only. The 19mm is about what I remember, 0.75". It's been several years since I bought ...   09-01-2013 09:19 pm

Body & interior stuff > Sound Deadening and Heat Control (2 replies - 3437 views)

I'll see what I think when I get 14539 back on the road here. I went with stuff from a company called Second Skin Audio. ...   09-01-2013 08:43 pm

Electrical & Instruments > Starter running via the Ghost of Lucas? (23 replies - 11834 views)

I figured that I wouldn't need the external ballast resistor since it was included in the Flamethrower coil. It wasn't even present in this car. Jim, ...   08-18-2013 07:30 pm

Electrical & Instruments > Starter running via the Ghost of Lucas? (23 replies - 11834 views)

This is certainly timely as I am working on this in the garage now. Trying to wire up a Pertronix distributor along with the Flamethrower ...   08-18-2013 02:03 am

Electrical & Instruments > Starter running via the Ghost of Lucas? (23 replies - 11834 views)

According to the wiring diagram. There is a white/yellow wire from the starter to the coil. Then from there a white/yellow wire goes to the ballast ...   08-17-2013 07:39 pm

Suspension > firewall steering shaft bushing (15 replies - 11410 views)

I'm sure the bushing will last for a real long time. I asked someone who replaced the bushing about 6 - 7 years ago and ...   08-09-2013 11:48 pm

Body & interior stuff > Interior trim (10 replies - 5942 views)

Define match. Match as in perfect, probably not. Considering the originals are over 35 years old, allowing for age, weathering, type of material, etc. Matching close ...   08-07-2013 12:43 am

Suspension > firewall steering shaft bushing (15 replies - 11410 views)

Glad to be of help. You should be good for several years with that fix. On to the next item on your list I imagine. ...   07-31-2013 01:15 am

Cooling > AC (2 replies - 2667 views)

The AC was probably a dealer installed option. I would think you would have better luck getting a new under dash unit then try to fit ...   07-29-2013 01:50 am

Projects > Build custom car from scratch book (4 replies - 4269 views)

I thought this was an appropriate place to put this as the information it contains applies to so many of our projects in one way ...   07-25-2013 12:06 am

Electrical & Instruments > Decent wiring diagram (13 replies - 12906 views)

Thanks Mike. Just what I needed. I also sent it to Jody Kerr to see if he wants to host it for all of us. ...   07-24-2013 04:21 am

Electrical & Instruments > Decent wiring diagram (13 replies - 12906 views)

Did we ever determine if John's wiring diagrams were available somewhere? Working on wiring up one of my cars, 74 JH #14549, and it seems the ...   07-23-2013 09:52 pm

Body & interior stuff > Change GT from rubber to steel bumpers (1 reply - 2628 views)

The rear bumpers should swap out fine. The only difference I remember is the rear mounting brackets. On the GT they are U shaped. On ...   07-13-2013 08:30 pm

Suspension > firewall steering shaft bushing (15 replies - 11410 views)

You are correct that the shear pins are underneath the plastic cover and the mesh. I thought I had pictures of when I rebuilt my ...   07-11-2013 11:18 pm

Engine & Transmission > Hey dude, where's my compression? (2 replies - 2273 views)

Could be rings. Or valves. Unfortunately you won't know for sure until you open it up. If you decide to keep it I say an ...   07-05-2013 01:29 am

Engine & Transmission > Show Quality JH with Rover V8 (5 replies - 4252 views)

So the rest of you do not have to search. http://www.britishv8.org/Other/ErnieVicencio.htm Nice car and pictures. Some different ideas there. ...   07-05-2013 01:20 am

Suspension > firewall steering shaft bushing (15 replies - 11410 views)

Are you talking about the steering column bushing? Loosen the bolt on the knuckle that holds the spline end of the shaft. You will need to pry it ...   06-20-2013 04:22 am

Engine & Transmission > fan belts on later engines (4 replies - 2830 views)

Hmmm. This engine has a 3 groove pulley. Groove 1 (closet to engine) lines up with crank, water pump and where the air pump was. ...   06-19-2013 08:31 pm

Engine & Transmission > fan belts on later engines (4 replies - 2830 views)

I would if I could. The old air pump is rusted together and so far no amount of soaking and persuasion has loosen it. I'll rig ...   06-19-2013 02:32 am

Engine & Transmission > fan belts on later engines (4 replies - 2830 views)

I have an engine from a GT that I am getting ready to use. There was no fan belt that connected the air pump, fan ...   06-18-2013 04:43 pm

Electrical & Instruments > Oil Pressure/Temp T Fitting (5 replies - 3741 views)

Unfortunately I don't have an answer. Have you tried Delta? That is not a stock piece that came with the car as far as I know. ...   06-18-2013 04:20 pm

Body & interior stuff > Paint scheme question... front lip under bumper (and a bumper question too) (8 replies - 4625 views)

It's hard to tell with the reflection but some of those dents could be made smoother with a little hammer/dolly work. The rest should smooth ...   06-15-2013 12:45 am

Body & interior stuff > Paint scheme question... front lip under bumper (and a bumper question too) (8 replies - 4625 views)

It depends on how bad they are. It's generally better to try and smooth out the metal with a hammer and dolly before going to ...   06-12-2013 03:49 am

Body & interior stuff > Paint scheme question... front lip under bumper (and a bumper question too) (8 replies - 4625 views)

I checked and one is body color on both sides and the other is body color except for the top part where the oil cooler ...   06-09-2013 09:16 pm

Miscellaneous > Links to photos of Jensen East 2013 in Shepherdstown, WV (6 replies - 3876 views)

Thanks for sharing the pics Paul. ...   06-05-2013 02:13 am

Miscellaneous > Left out in the rain (4 replies - 2943 views)

Thanks for that. I had a good laugh. But I don't see why you were asking about seat belts as there is obviously no where to ...   06-05-2013 02:05 am

Engine & Transmission > Cover for rear axle (2 replies - 2018 views)

There is suppose to be a gasket. Delta has them. Or make your own. I'm not sure what the red dot is for. ...   05-15-2013 11:28 pm

Projects > 16173 will be entering project status... (158 replies - 84213 views)

Fixing the rocker, or is it rockers, is going to be a pain no matter how you look at it. Once you get the rocker ...   04-27-2013 11:48 pm

Suspension > Steering column rubber gasket replacement (2 replies - 3392 views)

Good idea! I can find edging here locally. Another idea, I can get a piece of the appropriate thickness of rubber and cut a smaller hole ...   04-23-2013 12:10 am

Suspension > Steering column rubber gasket replacement (2 replies - 3392 views)

I have been unable to find a replacement for the rubber gasket that the steering column goes through on the firewall. I am not talking ...   04-22-2013 07:04 pm

Suspension > Front suspension (45 replies - 38129 views)

It's dark here now so I can't go and check one of my cars. This might work to give you enough clearance. What if you loosen ...   04-22-2013 03:41 am

Suspension > Front suspension (45 replies - 38129 views)

If you are replacing all the bushings then removing the bolts won't matter. The car will need to be realigned. By leaving the bolts in ...   04-19-2013 02:03 am

Ignition > Gear reduction starter (8 replies - 6515 views)

If you look at the British Starters page they also list one for the Jensen Healey. And it's priced $15.00 more! Does this mean our ...   04-19-2013 01:38 am

Suspension > Front suspension (45 replies - 38129 views)

To answer your questions. 1. Yes. The strut is #50 in the picture. The round arm attaches to the lower control arm with two bolts. Don't ...   04-17-2013 05:01 pm

Cooling > Heater box vacuum valve purpose (4 replies - 4214 views)

That's kind of what I thought would need to be done and seems to be the general consensus. Now I need to find a valve ...   04-17-2013 04:45 pm

Cooling > Heater box vacuum valve purpose (4 replies - 4214 views)

While rebuilding the heater box from 14539 I needed to replace the small round plastic piece that fits in the hole of one of the ...   04-15-2013 06:38 pm


 Current time is 08:20 pm
 First Page Previous Page  1  2  3  4  5  6  7  8  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems