| ||||
|
Posts by cjwilson | |
---|---|
50 posts | Showing posts 41-50 of 50 |
Engine & Transmission > Need to change out the Timing Belt Tensioner (23 replies - 35850 views) Thanks Tim! I'll chime back in once I receive the bearings and start to work through this. ... 05-26-2019 02:09 pm Engine & Transmission > Need to change out the Timing Belt Tensioner (23 replies - 35850 views) Thanks Tim. I've ordered 2 good quality SKF 6005 rubber sealed bearings.
I've done a couple of timing chains so not overly concerned. I'll go slow ... 05-24-2019 06:39 pm Engine & Transmission > Need to change out the Timing Belt Tensioner (23 replies - 35850 views) Starting to get an intermittent bearing noise from the front of the engine. Have found it's the tensioner for the timing belt.
Is there a ... 05-23-2019 03:05 pm Engine & Transmission > Crazy no start issue for 73 JH # 12265 (7 replies - 8175 views) Hey Brett,
Thanks for answering. Yes fuel pressure is higher than I expected. Pump is newly purchased and installed. I purchased at a local "box" ... 05-21-2019 01:06 am Engine & Transmission > Crazy no start issue for 73 JH # 12265 (7 replies - 8175 views) To add to this... I checked for spark again. Strong spark that stops as soon as I let off the key. So spark is happening ... 05-19-2019 02:15 pm Engine & Transmission > Crazy no start issue for 73 JH # 12265 (7 replies - 8175 views) Updates: I checked fuel pressure at the carbs - 6.5psi
I checked compression - #1-93psi, #2-93psi, #3-104psi, #4-97psi.
I also checked spark at #1 and it's hot ... 05-18-2019 10:28 pm Engine & Transmission > Crazy no start issue for 73 JH # 12265 (7 replies - 8175 views) Hey guys, trying to resurrect #12265 after 10 years of hiding in the garage. Had to rebuild fuel tank and repair a few pinholes. New ... 05-18-2019 07:55 pm Ignition > Crazy no start issue for 73 JH # 12265 (3 replies - 5434 views) Hey guys, trying to resurrect #12265 after 10 years of hiding in the garage. Had to rebuild fuel tank and repair a few pinholes. Once ... 05-18-2019 07:49 pm Electrical & Instruments > Gauge Tags/Tach Testing (11 replies - 24461 views) I pulled the voltage stabilizer apart and cleaned and reconnected it. Now my temp gauge works but fuel gauge doesn't. I pulled the fuel tank ... 04-28-2006 01:23 pm Electrical & Instruments > Gauge Tags/Tach Testing (11 replies - 24461 views) Hey Mark-
My 73 JH had the Pertronix unit installed when I purchased it. It also had a non-functional tach, and no ballast resistor.
I fried the ... 04-24-2006 12:34 pm | |
Current time is 02:43 pm | 1 2 |