| ||||
|
Posts by Jim Ketcham | |
---|---|
208 posts | Showing posts 201-208 of 208 |
Carburetors > Dellorto Gas Feed Location (5 replies - 13954 views) Hello Brett,
You can run the fuel lines anyway you want as long as each carb is getting 2.5 psi of fuel pressure. I personally did ... 03-29-2005 07:34 pm Miscellaneous > JH VIN 17948 Restoration (4 replies - 12412 views) Hello John,
What appears to be louvers are just indentations in the 5 mph bumper. I believe they are on all the later 5 mph "rubber" ... 03-29-2005 03:26 pm Miscellaneous > JH VIN 17948 Restoration (4 replies - 12412 views) VIN 17948 is back on the road after 2 decades. It's restoration is almost complete (finishing touches still to be done) and now just needs ... 03-29-2005 02:37 pm Body & interior stuff > Doors (5 replies - 13448 views) John,
For what it's worth, I started at the stainless trim piece then stretched my vinyl out from there. That way, I did not have to ... 03-26-2005 05:46 pm Engine & Transmission > Head Gasket Silicone Procedure (0 replies - 7133 views) The restoration of JH 17948 is essentially complete. I will post pictures in the photo gallery shortly. The last hurdle was overcoming an external coolant ... 03-23-2005 02:27 pm Body & interior stuff > Doors (4 replies - 11812 views) Hello John,
Alas, you are right. I am describing the clips on the door lock. This is what happens when I rely on memory. You would ... 03-14-2005 09:25 pm Body & interior stuff > Doors (4 replies - 11812 views) John,
The rod slips into the insert and is held by a little hinged "locking arm" that snaps over the rod. Gently pry the "locking arm" ... 03-14-2005 02:06 pm Engine & Transmission > Front and Rear main seals, timing gear removal (6 replies - 15389 views) Hello Gary,
I had tried to respond to your post on the old board but it would not let me.
I have the same complaint about ... 03-13-2005 05:56 pm | |
Current time is 04:33 pm | 1 2 3 4 5 6 |