| ||||
|
Posts by Rick in Miami | |
---|---|
48 posts | Showing posts 41-48 of 48 |
Body & interior stuff > Painting a hard top (10 replies - 13004 views) IIRC I used a TR6 header rail seal for the JH header and Triumph or MG door seals to seal around the side windows. My ... 06-08-2017 06:48 pm Engine & Transmission > Jensen Healey Specific - Eccentric Tensioner Hub (46 replies - 58943 views) Qwerty - PM sent ... 06-07-2017 01:37 pm Engine & Transmission > Cam belt replacement (43 replies - 74775 views) I finally got to play with the belt tension yesterday. I started by tightening the tensioner counter-clockwise to a tension that caused a whine when ... 04-07-2017 02:18 pm Engine & Transmission > Cam belt replacement (43 replies - 74775 views) Thanks Tim – Advice well taken. I will try tightening further in increments (starting at the high end to introduce the whine) next week and ... 03-15-2017 09:45 pm Engine & Transmission > Cam belt replacement (43 replies - 74775 views) I did set the tension cold @ 47# with a Krikit. I included calculated hot specs only because they had been included in the T104 ... 03-15-2017 11:17 am Engine & Transmission > Cam belt replacement (43 replies - 74775 views) Using the Burroughs/Krikit comparison data I found either on this forum or perhaps a Lotus forum for the Gates T104 and also the recommended Burroughs ... 03-12-2017 09:39 pm Electrical & Instruments > JH TACHOMETER VS PERTRONIX IGNITION (18 replies - 38339 views) I am running my stock RVI JH tach with a Pertronix II. I still power my coil + terminal from the circuit that passes through ... 10-12-2016 06:43 pm Electrical & Instruments > Spiyda RVI Buffer (4 replies - 12318 views) I am running my stock RVI JH tach with a Pertronix II. I still power my coil + terminal from the circuit that passes through ... 10-12-2016 06:41 pm | |
Current time is 05:38 pm | 1 2 |