| ||||
|
Posts by Screenplay | |
---|---|
124 posts | Showing posts 41-80 of 124 |
Brakes > Pedalbox rebuild (14 replies - 24495 views) Only one of my cars had the gooey black sealant; I always figured a PO did that but perhaps not. I used either acetone or ... 05-09-2016 06:19 pm Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102190 views) Is this the 1/4" steel cover plate that bolts to each side of there transmission tunnel? If so, it has always been my understanding that ... 04-27-2016 05:04 pm Body & interior stuff > Tarunk lock spring gadget (6 replies - 9902 views) After looking at my own lock clip I see it is not as I remembered - it is an odd duck. If all else fails, ... 04-17-2016 06:27 pm Body & interior stuff > Tarunk lock spring gadget (6 replies - 9902 views) Frank,
I'm thinking it would be called the "lock cylinder retaining clip." My first thought was Delta but a quick look did not show it in ... 04-16-2016 08:57 pm Brakes > Lockheed Brake Cylinder (6 replies - 12266 views) Try Beck-Arnley part number 071-1481. It's a rebuild kit for the JH that also cross references with the Triumph TR7. And since it's a TR7 ... 04-01-2016 02:50 pm Projects > Got it started (76 replies - 107249 views) That would be great. I'd rather deal with the transmission sooner than later if there is a good source for parts. Feel free to pm ... 04-01-2016 01:39 am Projects > Got it started (76 replies - 107249 views) I noticed in your previous post that the trans shop got parts from the local BMW dealer. I'm assuming this is a 5 speed - ... 04-01-2016 01:16 am Engine & Transmission > Tensioner removal (6 replies - 10122 views) Hi Bruce,
Great news on the progress. Kudos to you for getting to know these cars. With four, it is likely you will have at least ... 03-27-2016 09:10 pm Engine & Transmission > Tensioner removal (6 replies - 10122 views) Hi Bruce,
Don't be too hard on yourself; there are a lot of little quirks on this car that need to be learned as you go ... 03-26-2016 08:12 pm Electrical & Instruments > Alternator Wiring (9 replies - 18651 views) Thank you -and good to know. I have no reason to replace or change anything regarding wiring, especially as it is not my strong suit. ... 03-18-2016 04:07 pm Electrical & Instruments > Alternator Wiring (9 replies - 18651 views) Thanks for the help. After reading that the brown wires are hot, and that it goes back to the battery, I remembered that the wire ... 03-18-2016 01:07 am Electrical & Instruments > Alternator Wiring (9 replies - 18651 views) I'm cleaning up the wiring harness in the engine bay on 18341 and have a question about the three wires going to the alternator - ... 03-15-2016 11:26 pm Electrical & Instruments > fuses (3 replies - 7351 views) Check out this pdf I found sometime back regarding American/Lucas fuses. It has Tim Engel's name on it - I don't know for certain that ... 03-06-2016 06:49 pm Cooling > rebuilding the water pump (11 replies - 21204 views) Hi Matthew,
You might check out these links below. I thought about doing it at one time but ended up buying a rebuilt with exchange. The ... 03-05-2016 10:32 pm Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102190 views) Congratulations on the progress; it sounds like you're in the home stretch. If you don't like the stock mirrors, there'e always bullet-style mirrors. Certainly it's ... 02-28-2016 05:13 pm Ignition > Timing (4 replies - 11210 views) Hi, I don't think I know enough to help diagnose the problem with the carb backfire or stalling, but the pics provided I believe are ... 02-22-2016 10:38 pm Brakes > Lockheed Brake Shoes (3 replies - 8288 views) I just wanted to add that I've had great luck sourcing NOS brake shoes (Lockheed style) from the UK through ebay. Even with shipping, I ... 02-02-2016 08:24 pm Projects > JH 17967 (31 replies - 43215 views) Martl;
Thanks for sharing the pics of your efforts. It is quite an impressive body of work.
Clinton ... 01-21-2016 07:51 pm Projects > More "bling" for the Jensen Healey (18 replies - 66318 views) Just my humble opinion? ... 01-16-2016 06:32 pm Engine & Transmission > compressor removal (6 replies - 10085 views) I was waiting to see if anyone was going to answer your query; I imagine there is a dearth of information regarding JH air conditioning. ... 01-01-2016 08:30 pm Engine & Transmission > Lotus 907 'short motor' (1 reply - 5587 views) Short motor sounds like short block, or just the bottom end of the engine: block, crank, pistons, rods, pan, etc. No head or anything above ... 01-01-2016 03:25 pm Miscellaneous > Holiday Time! (0 replies - 3910 views) I just wanted say Merry Christmas and Happy New Year, and to express a big thank you to all who have contributed to the forum ... 12-26-2015 02:32 am Brakes > rear wheel cylinder replacement (4 replies - 8762 views) The clip will flex and bend some. As I recall (it's been a while) it was just a matter a little force to slide it ... 12-11-2015 09:42 pm Brakes > rear wheel cylinder replacement (4 replies - 8762 views) I'm assuming that you are trying to slide the clip into the groove. It doesn't necessarily go back on the same way it came off. ... 12-11-2015 03:29 pm Carburetors > best place to have strombergs rebuilt (12 replies - 19533 views) I'd just like to second Joachim's comment about the throttle axel play. It's one thing to do it yourself as there's certainly nothing wrong with ... 12-09-2015 04:44 pm Suspension > Bushing kits (2 replies - 8340 views) Hi Stuart,
I went with Super Pro bushings after riding in a car with the hard urethane (Prothane?) bushings - just my opinion but the urethane ... 11-26-2015 06:37 pm Miscellaneous > Tail Light Unevenness (6 replies - 10924 views) Is yours an early or later model? Have you measured them? I just measured various distances on both my 18059 and 19451. I got the ... 11-22-2015 02:53 am Brakes > Brakes - rear lockheed (4 replies - 9508 views) HI David,
I have some pics of my Lockheed brakes as well as a pic of the exploded view from the workshop manual. However, I can't ... 11-20-2015 05:39 pm Body & interior stuff > Side view mirrors (4 replies - 10071 views) Hi Frank,
I believe these are the mirrors still being made in the UK. Do a search on ebay for "tex mirrors" and see what comes ... 11-16-2015 01:21 am Body & interior stuff > Original rubber jensen script mats front (5 replies - 10473 views) Hi Stuart,
I have a passenger side in black in good condition (no wear through) that I'd be willing to part with. I also have one ... 09-17-2015 05:32 pm Engine & Transmission > Differences between MkII engine and GT engine? (16 replies - 22054 views) I'd second Brett on the "e caviat emptor." No need to rehash old stuff but just go in with your eyes wide open. ... 09-16-2015 01:02 am Engine & Transmission > 5 speed longevity (20 replies - 30528 views) Glad to see this thread resurrected as it brings up a question I have.
Since this Getrag was an option on certain BMW 2002s, does this ... 09-07-2015 06:20 pm Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 17070 views) Hi Frank,
Great to hear it's coming together. And I'd like to second Joachim's point about the importance of the lower bushing on the steering column. ... 06-21-2015 07:21 pm Projects > 16173 will be entering project status... (162 replies - 259322 views) I have a feeling my dash is going to eventually look an awful lot like yours. Nice job! ... 06-09-2015 11:55 pm Projects > 16173 will be entering project status... (162 replies - 259322 views) The dash looks great - especially with the chrome trim rings. Is that the elm or the walnut? ... 06-09-2015 09:04 pm Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 17070 views) Hi Frank,
I have changed the steering shaft on mine so I hope I can offer some help; I don't know if this is the ... 06-06-2015 05:55 am Body & interior stuff > Dash Replacement (3 replies - 8104 views) John,
Thanks for the link - my 19451 came with lots of splits and curls on the dash pad and I had just figured on going ... 05-20-2015 06:08 pm Engine & Transmission > rebuilding a 3:73 differential (1 reply - 5331 views) Hi John,
John at SF Differential in South San Francisco. He's from the UK and cut his teeth on this stuff - he's been doing this ... 05-13-2015 01:42 am Projects > 18711 "Miss Jensen" (129 replies - 247064 views) Joachim,
I've been a JHPS member for nearly two years now and have seen your posts from time to time but until today had ... 05-01-2015 06:54 pm Electrical & Instruments > Hazard Lights (12 replies - 26494 views) Gordon, Thanks for suggesting the possibilities. I thought about those GT items but none of the colors from the GT diagram match - not even ... 04-07-2015 05:02 pm | |
Current time is 09:08 am | 1 2 3 4 |