| ||||
|
Posts by Screenplay | |
---|---|
124 posts | Showing posts 81-120 of 124 |
Electrical & Instruments > Hazard Lights (12 replies - 26525 views) Eric,
Just a quick note regarding wiring. I can't offer anything specifically about the hazard switch wires, but I have mysteries regarding other wiring on my ... 04-04-2015 02:07 am Miscellaneous > My JH & Delta (25 replies - 71223 views) Kurt, Thanks for clearing that up. My 19451 was built 12-22-74 and it would have meant that Jensen built more than 300 of them in ... 02-08-2015 09:24 pm Miscellaneous > My JH & Delta (25 replies - 71223 views) Very nice car and so clean - even the trunk carpet which usually shows some kind of wear. It must be one of the ... 02-07-2015 09:26 pm Miscellaneous > My JH & Delta (25 replies - 71223 views) John,
Great to hear of your experience with Mike at Delta. I had an issue with rear springs purchased there recently (highlighted in a post under ... 02-07-2015 06:55 pm Miscellaneous > My JH & Delta (25 replies - 71223 views) ... 02-07-2015 06:55 pm Projects > GT 30071 Rolling Restoration (34 replies - 54536 views)
Your GT looks great. Congrats on getting it in such roadworthy condition. ... 01-24-2015 06:35 pm Suspension > Front suspension (53 replies - 91028 views) Eric,
Yes, that does make good sense, especially if you're using a floor jack to push it all together. I always use an internal spring compressor ... 01-18-2015 12:35 am Suspension > Front suspension (53 replies - 91028 views) Hi Eric,
Flat side UP against the rubber seat that sits against the subframe. The lower control arm is shaped to accept the bottom of ... 01-17-2015 07:58 pm Suspension > Delta Motorsports Rear Springs (7 replies - 14372 views) You can see the difference on the two here. On the top with the new spring I can't even get the retainers close enough to ... 12-31-2014 05:18 am Suspension > Delta Motorsports Rear Springs (7 replies - 14372 views) Tom, These are the rear springs. I can't seem to load the photo to show, but your pic shows the pig tail just like mine. ... 12-31-2014 02:08 am Suspension > Delta Motorsports Rear Springs (7 replies - 14372 views) Just got my new Delta uprated springs powder coated and ran into an issue when I went to install them. It seems that the pigtail ... 12-30-2014 06:45 pm Body & interior stuff > JH5 Emblems (5 replies - 10508 views) The new and improved version looks great. Nice job.
Clinton ... 12-28-2014 09:37 pm Body & interior stuff > Stainless Steel Rocker Panels =? (3 replies - 7689 views) Hi Glen,
After tearing apart my own '74 and cutting out some of that rocker rust, I'd have to say keep it simple. Or as a ... 12-07-2014 06:42 pm Suspension > Front and Rear Suspension Rebuild (29 replies - 58203 views) Eric,
In this case the long bolt with a washer would probably work as well. I would just make certain that the pressure is distributed ... 12-01-2014 06:07 am Suspension > Front and Rear Suspension Rebuild (29 replies - 58203 views) After reading that last post I realized I should address what I said about freezing the bushing. At most, the metal will contract slightly but ... 12-01-2014 01:31 am Suspension > Front and Rear Suspension Rebuild (29 replies - 58203 views) Hi Eric, I don't have any pics so I'll try to describe it. Also, I'm assuming the new bushing has a metal sleeve around it ... 12-01-2014 12:57 am Body & interior stuff > Drain Holes (1 reply - 5043 views) Hi Nigel,
Yes, the stone guards must be removed to access the drain holes in those voids in front of and behind the doors (over, or ... 11-29-2014 11:55 pm Miscellaneous > JH "Spider" (8 replies - 33692 views) The Avenger - sounds like it has super powers! I don't recall if any mention was made in the Craigslist post about the engine, ... 11-26-2014 07:59 pm Suspension > Aftermarket Shock Replacements (31 replies - 61392 views) Eric,
It's not difficult to remove the spring with a spring compressor; it's really something that can easily be done by many home mechanics. Use ... 11-24-2014 08:07 pm Miscellaneous > JH "Spider" (8 replies - 33692 views) John; I don't have information on where it went but I did save some photos from the CL listing in Dallas - if we're talking ... 11-23-2014 03:00 pm Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) Well, the fuel pump is now operating. I guessed that the white wire (the one with the junction connected to the rear window defrost) was ... 11-18-2014 09:18 pm Carburetors > Dellorto DHLA 45 "P" (1 reply - 7341 views) The engine rebuild of 18059 is still a ways off, but I'm always on the lookout for parts I'll need. I've found a pair of ... 11-17-2014 02:34 am Fuel Stuff > Fuel Tank Drain Plug (2 replies - 8393 views) Looks like I should have started at my local hardware store. While it looks like 5/8" it's a exact match to 3/8" NPT. They matched ... 11-15-2014 06:46 pm Fuel Stuff > Fuel Tank Drain Plug (2 replies - 8393 views) Does anyone know what size the brass drain plug is on the JH tank? I just purchased an aluminum tank and would like to find ... 11-14-2014 01:43 am Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102355 views) Another option for side marker lights that looks good but still provides for nighttime visibility is to substitute 1968 Dodge/Plymouth lights (the ones that ... 11-01-2014 06:58 pm Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) The GT loom would certainly help explain some of the extra wires as well as the extra long wires to the fuel tank sending unit ... 11-01-2014 06:52 pm Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) 2nd Photo ... 10-31-2014 10:56 pm Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) This may be coming together; I've sorted out all of the rear lights and trunk mounted license plate lights, as well as the fuel sending ... 10-31-2014 10:56 pm Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) Thanks for all the replies. I just received the latest JHPS issue and there is a reference in one of the features about subtle wiring ... 10-31-2014 04:56 am Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) PS: I'm only working ion the trunk of this car at the moment (#19451). ... 10-29-2014 04:54 am Electrical & Instruments > Fuel Pump Wiring (11 replies - 18708 views) Perhaps somebody in the society could help me with a wiring issue I'm facing.
I'm sorting out the wiring on a late '74 model - #19451. ... 10-29-2014 04:52 am Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102355 views) I believe the rubber strips are in the Delta Motorsports catalog, listed as "finishers." I haven't seen these replacements in person but I have no ... 09-25-2014 02:59 pm Fuel Stuff > Custom Tank-No Breather/Pressure Relief (4 replies - 11196 views) Brett-thanks for the word on venting. It certainly makes sense that the vacuum created must be filled by new air. The previous owner claims to ... 09-24-2014 09:39 pm Brakes > Noise from Brake Pedal (26 replies - 40417 views) James,
Great to hear; it will be good to read about your thoughts after a little more time with it. Thanks for posting this-I believe it ... 09-19-2014 07:32 pm Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102355 views) I have 1974 JH and still haven't decided how to tackle the rear bumper issue. If there is one area of the JH design-regardless of ... 09-17-2014 03:53 pm Brakes > Noise from Brake Pedal (26 replies - 40417 views) You've certainly done your homework. Please do keep us posted; I'm very interested to hear how this works out. Best of luck with the project.
Clinton ... 09-17-2014 03:30 pm Projects > New Restoration Project Started - 13046 - Riverside, CA (70 replies - 102355 views) Nice looking project you have-that's quite a striking color and should really stand out. I look forward to updates and seeing it come together. ... 09-16-2014 01:37 am Brakes > Noise from Brake Pedal (26 replies - 40417 views) I forgot to add that I read in an online Land Rover forum that, depending on year and wheelbase, there are master cylinders that look ... 09-16-2014 01:31 am Brakes > Noise from Brake Pedal (26 replies - 40417 views) I can't say I'm familiar with the "chuff' sound you're experiencing, but I did want to comment on the choice of master cylinder. I was ... 09-16-2014 01:00 am Fuel Stuff > Custom Tank-No Breather/Pressure Relief (4 replies - 11196 views) I've located what appears to be a nicely constructed alloy JH tank but the top only has the filler neck; there is no breather or ... 09-15-2014 09:45 pm | |
Current time is 11:54 am | 1 2 3 4 |