| ||||
|
Posts by answerman | |
---|---|
435 posts | Showing posts 81-120 of 435 |
Electrical & Instruments > Rear and reverse circuit (8 replies - 14070 views) Before you go to too much hair pulling testing, let me mention (though you probably already know) that the ignition switch has to be on ... 10-03-2016 06:45 am Fuel Stuff > thickness of material for under gas tank (8 replies - 13112 views) I used sections of 12/2 Romex (residential building cable, what you've got for all the wiring in your house most likely). Cut about 4 ... 10-03-2016 06:32 am Miscellaneous > membership (1 reply - 4945 views) Hey Tom: just as a sharing of experience, Greg is not always consistent with sending out the newsletter. Actually I don't think I've seen ... 09-19-2016 09:03 pm Electrical & Instruments > Spiyda RVI Buffer (4 replies - 12268 views) Oh, for what it's worth... if this comes with the cable to calibrate the tach, I (along with other people here) found it basically unusable. ... 09-01-2016 05:37 pm Electrical & Instruments > Spiyda RVI Buffer (4 replies - 12268 views) Nope, never even heard of this one. Looks interesting. I actually bought the Spiyda conversion kit to internally convert my RVI tach to ... 09-01-2016 05:35 pm Body & interior stuff > seatbelt reel proper location (2 replies - 6006 views) I posted a picture a few years ago, had to go find it:
http://www.jensenhealey.com/forums/view_topic.php?id=1883&forum_id=11&highlight=seat+belt Basically: the reel mounts to the front of the bracket that's ... 08-05-2016 05:32 pm Electrical & Instruments > Tach only removal ? (2 replies - 6636 views) Easy peasy. Had to look but I found my writeup on this from a while back... http://www.jensenhealey.com/forums/view_topic.php?id=1524&forum_id=5&jump_to=14170#p14170
Make sure that when you look at the ... 07-01-2016 04:35 am VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 541204 views) Go back up to my post about 6 up the page... it will all become clear. ... 06-23-2016 05:05 am VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 541204 views) Q. What does it mean when a Jensen Healey stops leaking oil?
A. It's out of oil.
Seriously, I don't think there is such a thing ... 06-17-2016 06:39 pm Engine & Transmission > Delta 4 into 1 header and steering shaft again (4 replies - 7820 views) I don't quite have news yet (got back from Jensen East yesterday, which was a fabulous time had by all) but I did receive the ... 06-14-2016 04:19 am Engine & Transmission > Delta 4 into 1 header and steering shaft again (4 replies - 7820 views) Well, what changed was that the engine and transmission came out and went back in. The transmission mount and bracket are brand new (the ... 06-07-2016 07:29 pm Ignition > Misfire after 30 minutes (31 replies - 45551 views) I don't think there is much that even can be rebuilt on the gauge. For what it's worth, I do have one I pulled ... 06-06-2016 07:57 pm Engine & Transmission > Delta 4 into 1 header and steering shaft again (4 replies - 7820 views) Question for those of you who have installed the Delta 4 into 1 exhaust manifold and had to shim up the drivers side engine mount ... 06-06-2016 05:10 pm Engine & Transmission > Gear reduction starter wiring (9 replies - 14896 views) I have the same installation (might be a different starter but it's the same idea) and it was pretty straightforward. I'll try to get ... 05-20-2016 04:20 pm Engine & Transmission > '75 5 speed Question (9 replies - 12979 views) Bob Wall's been looking for a 5 speed rear end. I just sent him a FB message, maybe you two can work something out. ... 05-13-2016 04:17 pm Engine & Transmission > '75 5 speed Question (9 replies - 12979 views) Roverman, where are you located? ... 05-12-2016 09:18 pm Brakes > Pedalbox rebuild (14 replies - 24442 views) I used gray seam sealer, myself. It cleaned up pretty well with either acetone or mineral spirits, can't remember which. ... 05-10-2016 10:04 pm Ignition > Misfire after 30 minutes (31 replies - 45551 views) I doubt it's the tach (unless it's the actual bullet connectors on the tach itself just being dirty). The tach electronics proper don't actually ... 05-07-2016 05:19 am Projects > 16173 will be entering project status... (162 replies - 258697 views) Kinda laughing at myself tonight. Two issues, one caused by impatience and the other by not paying attention for like the 12th time I've ... 05-04-2016 06:42 am Projects > 16173 will be entering project status... (162 replies - 258697 views) Ms. Jenavieve's engine is reassembled and back in. Last night I finally got to the point where I could fill up all the fluids and ... 05-02-2016 06:11 pm Miscellaneous > 2016 East Coast Nationals (9 replies - 14210 views) Sent off my registration last week. I'll mention, since Brett didn't, that we have a bonus (from the Jensen East website):
"We have just been ... 04-14-2016 06:17 pm Electrical & Instruments > side marker replacement bulbs (6 replies - 11459 views) http://www.deltamotorsports.com/products/pg14a-exterior-lights.html
Item #32: LLB989 ... 03-11-2016 04:29 am Body & interior stuff > side window wipers/seals (3 replies - 7479 views) http://www.jensenhealey.com/forums/view_topic.php?id=1394&forum_id=11 ... 02-23-2016 04:11 pm Body & interior stuff > side window wipers/seals (3 replies - 7479 views) If you're speaking of the ones that mount on the outside of the window, they aren't terribly difficult. Much easier if the window isn't ... 02-23-2016 04:10 pm Electrical & Instruments > Starter Solenoid (4 replies - 9633 views) I have to disagree, Tim. That would be true of an ammeter, but since the JH has a voltmeter it's just a parallel ... 02-08-2016 04:17 am Miscellaneous > interchangeable parts (2 replies - 6534 views) Is this what you were looking for?
http://www.jensenhealey.com/forums/view_topic.php?id=1852&forum_id=10 ... 02-03-2016 06:44 pm Projects > JH 17967 (31 replies - 43172 views) You're right, this does look familiar. Nice job! I've done pretty much everything you've done, repairing rust in the exact same places, except ... 01-20-2016 06:24 pm Engine & Transmission > Valve guides (3 replies - 6886 views) Yup, just heard back from Greg. They are the same bronze ones Delta has, from the same manufacturer. ... 01-12-2016 04:48 pm Engine & Transmission > Valve guides (3 replies - 6886 views) Anyone? ... 01-12-2016 04:02 am Engine & Transmission > Valve guides (3 replies - 6886 views) Does anyone know if the valve guides in the club store are bronze, or steel? The ones Delta has are bronze, while the originals are ... 01-08-2016 07:27 pm Projects > 16173 will be entering project status... (162 replies - 258697 views) An update, because it's been a while.
Just heard back from the machine shop: the head is in very good shape overall, nice and ... 01-08-2016 06:49 pm Suspension > Rear spring assemblies (36 replies - 59617 views) laughs... that would be an interesting Frankenhealey! No, it's definitely the right manual. If anyone else wants to order it from the Amazon ... 01-07-2016 04:18 pm Suspension > Rear spring assemblies (36 replies - 59617 views) Just a follow up. I did receive the Haynes Vauxhall Viva HB manual I ordered from Amazon last week, and contrary to the cover ... 01-06-2016 08:07 pm Intro Tech Board stuff > 502 Bad Gateway error (4 replies - 11768 views) Actually, Greg made it even easier. All you have to do is to to the login page:
http://www.jensenhealey.com/forums/login.php
and click the "Reset the cookie used ... 01-03-2016 04:24 am Body & interior stuff > Question for those who have installed the Delta floor pans (3 replies - 7839 views) All right, I'm not even sure I understood my own explanation. I'll try to draw up what I'm talking about to explain better. ... 12-23-2015 09:14 pm Body & interior stuff > Question for those who have installed the Delta floor pans (3 replies - 7839 views) So, I'm in the process of making new floor pans for Ms. Jenavieve, and I'm getting close to having the drivers side done.
At the moment, ... 12-23-2015 04:46 am Engine & Transmission > Cam belt replacement (43 replies - 74453 views) Here. I have a very detailed explanation of how I did it (because I don't trust the gears to not turn). Probably overkill, ... 12-18-2015 06:21 am Suspension > Rear spring assemblies (36 replies - 59617 views) Watching this thread with interest since I am pulling Ms. J's front suspension at a minimum within the next few weeks. I did an ... 12-02-2015 04:32 pm Brakes > brake drum removal 75 jh (6 replies - 11127 views) Not my solution (a mix of Nigel's, Joachim's, and Kim's suggestions and trials) but glad it worked for you. I just know how to ... 12-02-2015 04:02 am Brakes > brake drum removal 75 jh (6 replies - 11127 views) Also, there's an exploded view here. The slot is in item #12 in the picture, right under the vertical red arrow that points down. ... 12-01-2015 05:05 pm | |
Current time is 11:20 am | 1 2 3 4 5 6 7 8 ... |