Home 
Home Search search Menu menu Not logged in - Login | Register
> answerman

Profile Topics Posts
Posts by answerman
383 postsShowing posts 41-80 of 383

Engine & Transmission > Delta 4 into 1 header and steering shaft again (4 replies - 1838 views)

Question for those of you who have installed the Delta 4 into 1 exhaust manifold and had to shim up the drivers side engine mount ...   06-06-2016 06:10 pm

Engine & Transmission > Gear reduction starter wiring (9 replies - 3062 views)

I have the same installation (might be a different starter but it's the same idea) and it was pretty straightforward. I'll try to get ...   05-20-2016 05:20 pm

Engine & Transmission > '75 5 speed Question (9 replies - 2273 views)

Bob Wall's been looking for a 5 speed rear end. I just sent him a FB message, maybe you two can work something out. ...   05-13-2016 05:17 pm

Engine & Transmission > '75 5 speed Question (9 replies - 2273 views)

Roverman, where are you located? ...   05-12-2016 10:18 pm

Brakes > Pedalbox rebuild (13 replies - 6928 views)

I used gray seam sealer, myself. It cleaned up pretty well with either acetone or mineral spirits, can't remember which. ...   05-10-2016 11:04 pm

Ignition > Misfire after 30 minutes (30 replies - 6725 views)

I doubt it's the tach (unless it's the actual bullet connectors on the tach itself just being dirty). The tach electronics proper don't actually ...   05-07-2016 06:19 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Kinda laughing at myself tonight. Two issues, one caused by impatience and the other by not paying attention for like the 12th time I've ...   05-04-2016 07:42 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Ms. Jenavieve's engine is reassembled and back in. Last night I finally got to the point where I could fill up all the fluids and ...   05-02-2016 07:11 pm

Miscellaneous > 2016 East Coast Nationals (9 replies - 3592 views)

Sent off my registration last week. I'll mention, since Brett didn't, that we have a bonus (from the Jensen East website): "We have just been ...   04-14-2016 07:17 pm

Electrical & Instruments > side marker replacement bulbs (6 replies - 2376 views)

http://www.deltamotorsports.com/products/pg14a-exterior-lights.html Item #32: LLB989 ...   03-11-2016 05:29 am

Body & interior stuff > side window wipers/seals (3 replies - 1770 views)

http://www.jensenhealey.com/forums/view_topic.php?id=1394&forum_id=11 ...   02-23-2016 05:11 pm

Body & interior stuff > side window wipers/seals (3 replies - 1770 views)

If you're speaking of the ones that mount on the outside of the window, they aren't terribly difficult. Much easier if the window isn't ...   02-23-2016 05:10 pm

Electrical & Instruments > Starter Solenoid (4 replies - 2249 views)

I have to disagree, Tim. That would be true of an ammeter, but since the JH has a voltmeter it's just a parallel ...   02-08-2016 05:17 am

Miscellaneous > interchangeable parts (2 replies - 1343 views)

Is this what you were looking for? http://www.jensenhealey.com/forums/view_topic.php?id=1852&forum_id=10 ...   02-03-2016 07:44 pm

Projects > JH 17967 (31 replies - 8207 views)

You're right, this does look familiar. Nice job! I've done pretty much everything you've done, repairing rust in the exact same places, except ...   01-20-2016 07:24 pm

Engine & Transmission > Valve guides (3 replies - 1738 views)

Yup, just heard back from Greg. They are the same bronze ones Delta has, from the same manufacturer. ...   01-12-2016 05:48 pm

Engine & Transmission > Valve guides (3 replies - 1738 views)

Anyone? ...   01-12-2016 05:02 am

Engine & Transmission > Valve guides (3 replies - 1738 views)

Does anyone know if the valve guides in the club store are bronze, or steel? The ones Delta has are bronze, while the originals are ...   01-08-2016 08:27 pm

Projects > 16173 will be entering project status... (135 replies - 81139 views)

An update, because it's been a while. Just heard back from the machine shop: the head is in very good shape overall, nice and ...   01-08-2016 07:49 pm

Suspension > Rear spring assemblies (36 replies - 17658 views)

laughs... that would be an interesting Frankenhealey! No, it's definitely the right manual. If anyone else wants to order it from the Amazon ...   01-07-2016 05:18 pm

Suspension > Rear spring assemblies (36 replies - 17658 views)

Just a follow up. I did receive the Haynes Vauxhall Viva HB manual I ordered from Amazon last week, and contrary to the cover ...   01-06-2016 09:07 pm

Intro Tech Board stuff > 502 Bad Gateway error (4 replies - 3289 views)

Actually, Greg made it even easier. All you have to do is to to the login page: http://www.jensenhealey.com/forums/login.php and click the "Reset the cookie used ...   01-03-2016 05:24 am

Body & interior stuff > Question for those who have installed the Delta floor pans (3 replies - 1993 views)

All right, I'm not even sure I understood my own explanation. I'll try to draw up what I'm talking about to explain better. ...   12-23-2015 10:14 pm

Body & interior stuff > Question for those who have installed the Delta floor pans (3 replies - 1993 views)

So, I'm in the process of making new floor pans for Ms. Jenavieve, and I'm getting close to having the drivers side done. At the moment, ...   12-23-2015 05:46 am

Engine & Transmission > Cam belt replacement (43 replies - 9383 views)

Here. I have a very detailed explanation of how I did it (because I don't trust the gears to not turn). Probably overkill, ...   12-18-2015 07:21 am

Suspension > Rear spring assemblies (36 replies - 17658 views)

Watching this thread with interest since I am pulling Ms. J's front suspension at a minimum within the next few weeks. I did an ...   12-02-2015 05:32 pm

Brakes > brake drum removal 75 jh (6 replies - 2566 views)

Not my solution (a mix of Nigel's, Joachim's, and Kim's suggestions and trials) but glad it worked for you. I just know how to ...   12-02-2015 05:02 am

Brakes > brake drum removal 75 jh (6 replies - 2566 views)

Also, there's an exploded view here. The slot is in item #12 in the picture, right under the vertical red arrow that points down. ...   12-01-2015 06:05 pm

Brakes > brake drum removal 75 jh (6 replies - 2566 views)

From this thread when I was trying to get my handbrake adjusted last summer: "You should however, as Joachim says, be able to completely slacken off ...   12-01-2015 06:02 pm

Engine & Transmission > 4 speed transmission crossmember (1 reply - 1058 views)

Posted on the Facebook group with no response, so here I am: Planning ahead... who's got a transmission mount crossmember for a 4 speed that doesn't ...   11-20-2015 07:45 pm

Body & interior stuff > Side view mirrors (4 replies - 1779 views)

Hi Frank! Got these from Victoria British last year, they are very original looking and you can get the plinth kits as well. http://www.victoriabritish.com/features/sm/smmi1.htm My thread for last ...   11-16-2015 05:25 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

I am assuming it's already there (the head was removed about 7 years ago), I wasn't quite sure where to look for it. I ...   11-06-2015 08:39 pm

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Whoops, duplicate post. I'll save this for the next time I have something to report. ...   11-06-2015 04:45 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Cam towers are removed (learned a bit about how to keep the shims in place in the process, only had two fall out but I ...   11-06-2015 04:45 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

After a thorough degreasing and pressure washing of the engine, the new rear main seal was installed this weekend. It went pretty uneventfully. Tip: ...   11-02-2015 09:11 pm

Ignition > Spark plugs not firing (2 replies - 1366 views)

Maybe too simple of a test, but have you tried swapping a couple of the plugs? Pull #2 and #4 plugs out, swap them, ...   11-02-2015 09:08 pm

Engine & Transmission > Rear Main Seal and Oil Thrower (1 reply - 1203 views)

After removing the rear main seal cover, I see a couple of issues, and figured I'd run them by the experts here. First, though ...   10-30-2015 04:39 am

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Engine came out last weekend without too much hassle and is now sitting on/strapped to a workbench I built just for the occasion, since it ...   10-28-2015 08:28 pm

Brakes > Master Cylinder (4 replies - 2060 views)

Hey Kurt. I have my old TR6 style master cylinder in the big pile o'parts (I think I kept it, anyway) and though the ...   10-27-2015 09:01 pm

Projects > 16173 will be entering project status... (135 replies - 81139 views)

Thanks for the input, guys. Still haven't gotten an answer on the size of the bell housing bolts as far as mounting to the ...   10-22-2015 07:36 pm


 Current time is 01:26 am
 First Page Previous Page  1  2  3  4  5  6  7  ...  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems