Home 
Home Search search Menu menu Not logged in - Login | Register
> Frank Schwartz

Profile Topics Posts
Posts by Frank Schwartz
259 postsShowing posts 121-160 of 259

Ignition > Pertronix failure (1 reply - 1661 views)

Working on a friends JH and we replace the coil with a Blaster (MSD) coil and the recommended resistor and used a Pertronix unit in ...   11-02-2015 04:14 pm

Ignition > Misfire (5 replies - 2846 views)

The problem could be a plug wire not plugged into the distributor cap..it is so tight under there that when you try to put the ...   11-02-2015 05:42 am

Brakes > Master Cylinder (4 replies - 2524 views)

FYI...bought a new TR6 Master Cylinder to replace one that was bad on a friend's JH...new one looks great and is exactly as the ...   10-25-2015 08:49 pm

Engine & Transmission > Oil Cooler hoses (11 replies - 4235 views)

Are yours the originals? If so they are what, 40+ years old?? I'd recommend replacing them...you can get new ones like the originals ...   10-25-2015 07:09 am

Electrical & Instruments > Spoeedometer calibration (4 replies - 2854 views)

Fuzzy thinking on my part...that should be Turns per Mile... So how many turns per mile does a Smiths JH speedo turn...or whatever it might ...   10-21-2015 06:53 am

Electrical & Instruments > Spoeedometer calibration (4 replies - 2854 views)

Can anyone tell me how many turns per minute equates to on the dial. Such as 1000 Turns per minute equals 60 Miles Per ...   10-20-2015 11:00 pm

Projects > More "bling" for the Jensen Healey (16 replies - 7028 views)

Hving come froma car show where my Inteerceptor was put in a class with three very nice Jensen Healeys, I took first in that ...   10-13-2015 04:12 pm

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

Kurt: If I knew the answer, I'd write it up. Now that things are back to "normal" with 0 degrees static, it idles at 10 ...   08-08-2015 04:53 am

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

Well, talk about a combination of errors...mainly throttle cable hanging and a bad tachometer...things now back to normal...idle at 10 degrees, but have to change ...   08-06-2015 04:02 am

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

Yes, all timing marks are correct....so now I am checking fuel and air...no air leaks, removing carbs to make sure butterfly valves are completely closed...then ...   08-05-2015 05:27 pm

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

No luck yet. I have all the marks lined up as per the manual and I have done this a dozen times in the ...   08-05-2015 05:12 am

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

Yes...and this is crazy...#1 is at TDC..the mark on the crank pulley is lined up with 0 TDC and the cam markings match that is, ...   08-02-2015 05:34 am

Engine & Transmission > Sprocket timing (14 replies - 5746 views)

I just put a new belt on a JH and now I cannot get the engine to run but when it does fire, it ...   08-01-2015 07:22 pm

Engine & Transmission > Loose 4 speed shifter (4 replies - 2229 views)

Gentlemen: It is not the shifter shaft, etc. It is the entire shifter assembly where it bolts to the transmission way up inside the tunnel... I ...   07-28-2015 05:53 am

Engine & Transmission > Loose 4 speed shifter (4 replies - 2229 views)

Seems the JH my son and I are working on has a loose 4 speed transmission shifter. It is held in place with six ...   07-27-2015 04:32 am

Ignition > John Kimbrough's web page (1 reply - 1999 views)

I tried to access John's web page but he must have changed his web page address, as what I keep typing in does not work. Anyone ...   07-07-2015 09:08 am

Engine & Transmission > Cam Pulleys (5 replies - 3342 views)

I have never had to use a puller on the crankshaft pulley. Remove the bolt and with a small hammer, like a ball peen hammer, ...   06-30-2015 09:14 pm

Projects > Got it started (76 replies - 28937 views)

NO...but you have to remove the two wire leads to the switch to remove the pedal assembly...and remember when you put it all back together, ...   06-23-2015 08:35 am

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

I will check that bushing...but it seems to be fairly tight..that is the remaining steering shaft seemed to be solid and tight in situ.. ...   06-23-2015 12:14 am

Projects > Got it started (76 replies - 28937 views)

That works...but don't forget also to unplug the two wire leads to the brake switch.... ...   06-23-2015 12:12 am

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

Clinton...nd anyone else reading the thread.....I followed your instructions and the rack definitely needed to be removed or loosened...see my comments on the bolt head ...   06-19-2015 06:12 pm

Suspension > D shaped bolts holding steering rack (1 reply - 1945 views)

While trying to remove the steering shaft with the many u joints, I found it necessary to loosen the steering rack. There I found two ...   06-19-2015 06:07 pm

Cooling > fan clutch (18 replies - 9064 views)

My GT (sold later) had a viscous coupled fan on it and I found a replacement from Delta Motorsports..am sure they still have them. Anyhow, ...   06-13-2015 06:11 am

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

Andy...I thought you were in the Atlanta area...I am in the Nashville area, not too far from you. I do have a lathe ...   06-09-2015 03:47 am

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

Andy, re reading you post above, since you did the job yourself, I 'd like to know where you obtained the parts.. I see you are ...   06-06-2015 03:47 pm

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

Interesting...I can see that the U joint right at the top of the assembly is badly worn...have replaced U joints on drive shafts, but this ...   06-06-2015 03:45 pm

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

As the British say...Brilliant !! Thank you Clinton...this is exactly the information I needed Frank ...   06-06-2015 06:27 am

Body & interior stuff > Deadly loose steering...crazy U joints (11 replies - 5730 views)

Fellow Jensenites, as you know, there is always something that comes up that you have never encountered before on your beloved Jensen Healey...and this one ...   06-06-2015 03:23 am

Accessories > Jensen GT steering wheel (5 replies - 4632 views)

I found one in a junk yard...even then, not cheap..and the horn button and emblem from the UK cost as much as the steering wheel....still ...   06-01-2015 08:12 am

Cooling > fan clutch (18 replies - 9064 views)

Odd...all three of the GT's that I worked on had the viscous coupling fan...and it worked well on two and not on one..even when I ...   05-23-2015 05:51 am

Cooling > fan clutch (18 replies - 9064 views)

Odd...all three of the GT's that I worked on had the viscous coupling fan...and it worked well on two and not on one..even when I ...   05-23-2015 05:51 am

Cooling > Radiator cap (11 replies - 5502 views)

Thanks, Jim...that is what I needed to find out..someone with an original cap ...so off tot he car parts store for 7psi cap.. Thank you, Frank ...   04-30-2015 10:26 pm

Cooling > Radiator cap (11 replies - 5502 views)

I understand...the book does say 10 pounds, but I have yet to find where anywhere it states that the radiator cap is of any pounds...and ...   04-30-2015 04:11 am

Cooling > Radiator cap (11 replies - 5502 views)

7 pounds? Really? Are you absolutely sure? I mean, really, really sure? If so, where can I find that information? Thanks Frank ...   04-29-2015 11:47 pm

Cooling > Radiator cap (11 replies - 5502 views)

Hmmmm...I see 25 people viewed this inquiry and not a single one of you had an answer...shame on you, fellow Jensenites.... Frank Schwartz ...   04-29-2015 07:58 pm

Cooling > Radiator cap (11 replies - 5502 views)

I think I may be forgetting things.... Our JH was leaking coolant from under the radiator cap when the engine came up to temp. ...   04-29-2015 05:29 am

Body & interior stuff > Jensen GT steering wheel (1 reply - 1883 views)

Does anyone out there have a Jensen GT steering wheel with center cap they will trade or sell me?? Thank you, Frank Schwartz ...   04-03-2015 05:34 am

Electrical & Instruments > auxiliary relay box (1 reply - 2018 views)

Not at all...I use three relays and tap into the horn, high and low beams wiring right in front of the radiator..one lead from the ...   04-03-2015 05:29 am

Accessories > Jensen GT steering wheel (5 replies - 4632 views)

Does anyone out there have a Jensen GT steering wheel with center cap they will sell or trade to me. I found one ...   04-03-2015 05:23 am

Projects > Got it started (76 replies - 28937 views)

Gave you the wrong email site...the web site is www.advanceddistributors.com and the unit is listed for the 22D and 25D distributors and is as I ...   03-06-2015 08:23 pm


 Current time is 03:09 pm
 First Page Previous Page  1  2  3  4  5  6  7  Next Page Last Page


UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems