| ||||
|
Posts by Jensen Healey | |
---|---|
983 posts | Showing posts 321-360 of 983 |
Suspension > Steering (7 replies - 14017 views) Could be the steering rack. ... 06-12-2012 04:46 am Miscellaneous > Jensen West 2012 (6 replies - 10930 views) The event organizers have added a Saturday only option for attending. Please check the website.
http://jensenwest2012.com/
... 06-06-2012 03:23 pm Miscellaneous > Jensen West 2012 (6 replies - 10930 views) I'm doing some touch-up in preparation for the Western Nationals. Anyone else planning on coming?
Kurt ... 06-05-2012 03:42 pm Brakes > front rotor thickness (17 replies - 38371 views) If the MC, rear brake cylinders and the brake servo are OK, get some Hawk 118 pads and braided brake hoses. Flush the system with Dot ... 06-05-2012 06:29 am Miscellaneous > Jensen Healey vintage racing (5 replies - 10995 views) Wow! I saw the Lee Mueller car #43 today at Infineon Raceway (wine country, CA) sitting on the back of a Huffacker truck.
There was ... 06-03-2012 04:02 am Carburetors > Dellorto Filters? (7 replies - 16227 views) Just to clarify, The air filter is from a 1989 Jag XJS and my airbox is an aftermarket reproduction of the Eclat unit. It sounds ... 06-01-2012 02:02 am Miscellaneous > Jensen West 2012 (6 replies - 10930 views) Bump ... 05-25-2012 01:34 pm Miscellaneous > Jensen West 2012 (6 replies - 10930 views) Holy Smoking Strombergs, I just saw this link on the Delta webpage:
http://jensenwest2012.com/
I'll be there!
Kurt
... 05-10-2012 12:32 am Ignition > Timing (8 replies - 17427 views) Use a test light. Google up the procedure with points or Pertronix. ... 05-09-2012 01:03 am Carburetors > Dellorto Filters? (7 replies - 16227 views) An air box from the Lotus Eclat helps keep the noise slightly below ear splitting. It holds a flat panel air filter and draws cold air ... 04-21-2012 11:05 pm Carburetors > DHLA 40 vs. 45 (26 replies - 97209 views) I've had that happen on #4. I would re-check the timing, (12 degrees BTDC,) the float levels and the needle valves. Stick a finger in ... 04-09-2012 02:47 am Engine & Transmission > Seals seals and more seals (6 replies - 10774 views) Use a course file to file down the flats on the sump plug. These were 3/4 Whitworth so most are chewed up from the old ... 04-08-2012 02:42 pm Ignition > Crankshaft pulley (8 replies - 16993 views) I have one for you John. I will send a private message.
Kurt
... 04-05-2012 07:19 pm VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 542009 views) Hi Tony, Is this the 4th Jensen Healey built? ... 04-05-2012 07:11 pm Carburetors > DHLA 40 vs. 45 (26 replies - 97209 views) Hi Bob, The main jet and emulsion tube are not functioning in the 2- 3k range. Your issue is in the idle circuit which operates ... 04-05-2012 01:57 pm Engine & Transmission > toyota 5 speed conversion jig extension results (7 replies - 11032 views) Ha Ha! Selling anything involves the IRS. You would need a business license, federal tax I.D., liability insurance, book keeper, accoutant, etc.
Then you'd have to ... 04-04-2012 01:22 am Miscellaneous > Fender bender (9 replies - 17485 views) My old SAAB got hit by a simi while it was parked. I never got a dime from their insurance. Even if you get a ... 03-27-2012 06:21 pm Engine & Transmission > Getrag 5spd bell hosuing and shifter parts? (1 reply - 5073 views) Sent you a PM. Kurt ... 03-25-2012 03:01 pm Engine & Transmission > 5sp vs 4sp differential (4 replies - 9013 views) If the large flange and Lockheed brakes are there then it has potential. I remember turning the flange and counting rotation on the drive side.
I ... 03-25-2012 02:48 pm Engine & Transmission > Rebuilding GT Oil Pump (3 replies - 7003 views) Hi Bill,
A few SoCal shops are listed in the tech section:
http://www.jensenhealey.com/html/repair.html
Good Luck, Kurt
... 03-23-2012 03:32 am Engine & Transmission > Cam pulley timing marks (18 replies - 35971 views) If the budget is near $0 then your course is clear. When I was 16 years old we used to "rebuild" an engine by lapping ... 02-27-2012 06:34 pm Wheels > 205/60-13 Tires (36 replies - 79153 views) I guess we should be happy we have lived long enough to join the ranks of classic cars that can't find decent rubber.
My Sumitomo 205/60-13 ... 02-27-2012 04:05 am Electrical & Instruments > Turn Signal/ wiper Switch Clamp Broken (3 replies - 8921 views) I have finally experienced the dreaded broken plastic mounting ring. Being lazy and not wanting to look for my spare I used the magic 5 ... 02-26-2012 02:20 am Electrical & Instruments > Wiper gear stripped? (4 replies - 8906 views) Great write-up Jody. Thankfully I didn't have to go that far! ... 02-26-2012 02:02 am Electrical & Instruments > Wiper gear stripped? (4 replies - 8906 views) Thanks Mitch! I didn't need to unscrew the nut holding the cable because it was already loose. I tightened it up and problem solved!
Another 5 ... 02-25-2012 09:07 pm Electrical & Instruments > Wiper gear stripped? (4 replies - 8906 views) My wipers failed during an foggy run to the Monterey Historics last August. Since the steering wheel is off to repair the plastic collar on ... 02-25-2012 05:13 pm Engine & Transmission > Cam pulley timing marks (18 replies - 35971 views) Hi Tim, if you look at the intake and exhaust markings you will see that one pulley needs to be flipped. In 110 and ... 02-25-2012 12:18 am Engine & Transmission > 907 vs 910 (14 replies - 26667 views) Thanks James! Here's some info and photos of the Lotus 909:
http://www.projectm71.com/Rudd.htm
http://www.lotusbuzz.com/forums/showthread.php?t=697
... 02-11-2012 03:25 am Engine & Transmission > Clutch Throwout-Bearing Pivot (4 replies - 8097 views) Sorry it took so long Paul. Are the rest of the parts the same for either trans? Release lever, throwout bearing etc?
Kurt
... 02-09-2012 09:04 pm Engine & Transmission > Clutch Throwout-Bearing Pivot (4 replies - 8097 views) Hi Paul,
I measured the 5 speed pivot from the inside of the bellhousing to the top of the ball on the pivot at 2.050". Perhaps ... 02-09-2012 06:54 pm Miscellaneous > NorCal Cars & Coffee (1 reply - 5546 views) Some photos at:
http://hooniverse.com/2012/02/06/sausalito-cars-and-coffee-meet/
Added Feb. 7:
http://www.facebook.com/photo.php?fbid=174485322653839&set=pu.160155830753455&type=1&theater
... 02-08-2012 01:01 am Engine & Transmission > 907 vs 910 (14 replies - 26667 views) Subwoofer did it.
http://www.jensenhealey.com/forums/view_topic.php?id=1209&forum_id=15&highlight=modified+sump
Scroll down to the 40th post ... 02-06-2012 02:11 pm Miscellaneous > NorCal Cars & Coffee (1 reply - 5546 views) Today I attended the first First Saturdays Cars and Coffee across from Poggio’s Restaurant in Sausilito which is just north of the Golden Gate Bridge. ... 02-04-2012 07:29 pm Engine & Transmission > .060" over pistons (8 replies - 14941 views) It wouldn't be so bad, but not worth the money. ... 02-01-2012 01:23 am Engine & Transmission > .060" over pistons (8 replies - 14941 views) The 907 is already substantially over square and has real issues with torque at under 3500 rpm. Boring the cylinders .060 over will only make ... 01-31-2012 01:19 am Engine & Transmission > Pilot Bearing (6 replies - 9559 views) Mine was trashed so I used a small screwdriver and a hammer. ... 01-15-2012 12:39 am Engine & Transmission > Aux Pulley removal (7 replies - 11212 views) I agree Art! Maybe this should be service bulletin 12-1!
Kurt
... 01-06-2012 11:49 pm Engine & Transmission > Aux Pulley removal (7 replies - 11212 views) My spare aux shaft has a frozen pulley on the end of it. Good to know I'm not the only one! I was going to ... 01-04-2012 12:32 am VIN Database for Jensen Healey & Jensen GT > Jensen Healey & Jensen GT VIN Database (342 replies - 542009 views) Welcome to the board! There's a bolt schedule somewhere. I'll have a look.
Kurt JH 13148
... 01-04-2012 12:29 am Engine & Transmission > Suggestions: Engine Rebuild/Upgrade (2 replies - 7501 views) Hi Bob,
My setup is similar to what you propose:
Stock crank balanced with the stock flywheel, pressure plate, pistons and rods.
107 cams with 104 sprockets.
JAE ... 12-22-2011 01:57 am | |
Current time is 06:34 pm | ... 4 5 6 7 8 9 10 11 12 13 14 ... |