| ||||
|
Posts by JodyFKerr | |
---|---|
48 posts | Showing posts 41-48 of 48 |
Cooling > Delta's heater-valve conversion from vacuum to mechanical (16 replies - 32242 views) Well, yes and no.
The way that the heater box is configured those two main vents will never be as warm as the air flow through ... 05-29-2008 02:45 pm Cooling > Heater fan, procedure for removal? (1 reply - 7889 views) The heater blower motor cannt be removed without removing the whole heater unit.
Refer to: http://www.theymightberacing.com/Projects/FrameOff/JH74G/HeaterAssemblyRestoration.aspx
Jody
... 05-28-2008 01:12 pm Electrical & Instruments > Change bulb in side marker? (4 replies - 9696 views) If the rubber is worn out you can get replacements from Delta. ... 05-13-2008 08:15 pm Electrical & Instruments > Rear and position lights junction? (5 replies - 10360 views) Ahh, my pologies, and the memory in this area is kinda fuzzy.
I checked the harness in my primary JH. The lead wire is ~10" and ... 05-11-2008 02:53 pm Electrical & Instruments > Rear and position lights junction? (5 replies - 10360 views) The red positive wire runs all the way up to the front, underneath the dashboard. If I remember correctly it connects to the back of ... 05-11-2008 05:02 am Body & interior stuff > JH Heater Restoration Article (1 reply - 6319 views) Hi All,
Just published my latest bit of work. This covers the restoration of
the JH Heater assembly for my current JH project.
http://www.theymightberacing.com/Projects/FrameOff/JH74G/HeaterAssemblyRestoration.aspx
Cheers!
Jody
... 04-24-2008 05:25 pm Brakes > Brake Booster (11 replies - 49568 views) Jay,
I just went through my brakes on my current JH restoration project and asked the same question as you regarding the brake booster. The reality ... 03-31-2008 09:10 pm Brakes > Different viewpoints on brakes (16 replies - 32783 views) Greg,
Quick question on the brake lines. Did you make your own, or is there a source that has them already bent and flared? As soon ... 02-29-2008 04:15 pm | |
Current time is 08:32 pm | 1 2 |