| ||||
|
Posts by Jay | |
---|---|
73 posts | Showing posts 41-73 of 73 |
Miscellaneous > Jensen-Healey and GT noted in "Collectible Automobile" (1 reply - 6591 views) I was speaking to the PO of my 74 JH. He told me about an article he saw in a current copy of "Collectible Automobile". ... 08-07-2006 08:49 pm Miscellaneous > Anyone looked at the Repair Manual 72-76 CD? (3 replies - 13832 views) I spent $21.83 USD including shipping. The CD has some other information on it also. Most of it I had already seen at various websites. ... 07-11-2006 04:35 pm Miscellaneous > 2006 Jensen Nationals Web Site (12 replies - 22367 views) I was also interested to know how things went. Any comments?
... 06-13-2006 03:08 pm Ignition > Cap and Rotor (6 replies - 16973 views) The number that appears on mine is 41584A (the last part is not too clear). The underside (viewed with a small mirror) appears to only ... 05-10-2006 05:54 pm Ignition > Cap and Rotor (6 replies - 16973 views) I seem to have developed some spark tracking on my distributor's rotor. I also found a loose plug wire and I suspect that it contributed ... 05-09-2006 06:27 pm Body & interior stuff > Seat recovering (11 replies - 24098 views) Does anyone have any ideas on how to remove the seat mounting screws when the blind nut in the body rail does not appear to ... 05-01-2006 04:59 pm Body & interior stuff > side light fasteners (3 replies - 8917 views) If I were to try to fix this myself, can anyone tell me what sort of metal (or other material) the studs are made of. ... 04-28-2006 04:44 pm Body & interior stuff > side light fasteners (3 replies - 8917 views) Has anyone been able to repair (solder or some other means) a broken screw stud on a side marker light? I broke one on my ... 04-25-2006 03:11 pm Wheels > Original Wheels (17 replies - 37587 views) Does anyone have suggestion related to refinishing the original aluminum wheels. The paint is comeing off and I would like to remove all the paint ... 03-24-2006 04:34 pm Body & interior stuff > Metal Trim (4 replies - 9554 views) I'm in the process of sanding down my rear fender. I would like to remove the short vertical stainless trim that is attached to the ... 03-22-2006 12:58 pm Miscellaneous > New JH owner seeks guidance (22 replies - 38828 views) If I understand Mark correctly, I can easily remove the top covers from my Stromberg carbs. I was wondering if this could be done without ... 03-14-2006 07:54 pm Body & interior stuff > Rust Repair (8 replies - 17066 views) I have just started into the rust repair at the rear right fender to rocker seam. My Jensen has a small weld adjacent to each ... 03-07-2006 04:44 pm Miscellaneous > The Shark (2 replies - 7236 views) Is there a way to see the recent additions to the Photo Gallery, like the recent messages on the board?
... 02-28-2006 03:57 pm Body & interior stuff > Rust Repair (8 replies - 17066 views) Thanks Brett, Ed and Gary. This is just what I was looking for. Gary's post in the photo Gallery is what I remember having seen. ... 02-23-2006 12:25 pm Body & interior stuff > Rust Repair (8 replies - 17066 views) I have rust at the seam between the rocker pannel and the lower front edge of the rear fender. Does anyone have an approach to ... 02-22-2006 04:49 pm Body & interior stuff > Sills - molding and paint (25 replies - 43758 views) This picture appears to be a JH5 (rubber bumpers). The composition of the picture, with Jensen Motors LTD in the background, leads one to believe ... 02-17-2006 01:20 pm Engine & Transmission > Combustion chamber volume (8 replies - 16112 views) Just a thought... With the head off, another method to measure the volume of the combustion chamber would be to use something like modeling clay. ... 11-17-2005 01:30 pm Body & interior stuff > Steering wheel question (9 replies - 19423 views) My 74 JH has the silver and black escutcheon plate at the center of the steering wheel. The rubber material around it is chipped showing ... 11-01-2005 04:43 pm Body & interior stuff > Stowing Convertible top (13 replies - 24347 views) I'm not clear on the procedure. When you say "Once you have the top undone..." are you implying that the top is completely removed from ... 11-01-2005 04:18 pm Accessories > Speedometer (1 reply - 12200 views) My speedometer has a rather bouncy needle. It can vary 10 MPH at any given time. I relubed the cable (I may do it again). ... 10-03-2005 05:03 pm Carburetors > Single Choke vs Double Choke (1 reply - 8567 views) My JH has two Stromberg Carbs. I see that just one has a choke cable connection. Can someone explain this choke system? I understand that ... 09-21-2005 04:54 pm Miscellaneous > My anniversary (5 replies - 11727 views) It will be a little while before I have my first anniversary with my Jensen Healey. I bought mine just a few months ago (mid ... 09-21-2005 04:48 pm Body & interior stuff > Dash Cap (2 replies - 9323 views) I'm contemplating the Dash Cap from Delta. The photo on the website shows the top. I was wondering if it covers the entire dash including ... 09-16-2005 08:22 pm Electrical & Instruments > Tach Red-Line (2 replies - 8752 views) Well that's interesting. I just looked up "MGB tachometer" on the internet. I saw some that look a lot like mine, with the orange range. ... 09-15-2005 04:06 pm Electrical & Instruments > Tach Red-Line (2 replies - 8752 views) Can anyone give some background information as to why my tachometer has an orange range from 5500 to 6300 RPM and a red range from ... 09-15-2005 02:48 pm Suspension > Noisy Over Bumps (3 replies - 10033 views) Mark,
Thank You Very Much for you informative reply. I'll be takeing the front shocks off soon. I will attempt to replace their bushings. Over the ... 09-09-2005 12:25 pm Suspension > Noisy Over Bumps (3 replies - 10033 views) In a search to find some of my road noise, I took a breif look under my Jensen Healey. I discovered that my right front ... 09-08-2005 04:49 pm Body & interior stuff > Paint Color formula (1 reply - 7507 views) Has anybody had a paint shop custom mix the Tangerine color and come up with a formula for the color? It is my understanding the ... 08-29-2005 02:24 pm Body & interior stuff > Seat Rail Fasteners (1 reply - 7059 views) Does anyone know the thread size and pitch of the socket head bolts that fasten the seat rails to the floorboards? They appear to be ... 08-17-2005 05:38 pm Body & interior stuff > Rust Conditioning products (3 replies - 9828 views) I checked the Eastwood web site. They have a reprint of an artical from AUTO RESTORER, November 2003, that compares "Rust Encapsulator" to "POR-15" Upon ... 08-17-2005 02:29 pm Body & interior stuff > Rust Conditioning products (3 replies - 9828 views) I have scraped the rust scale from my floorboards. I have just a few small holes. I was considering brazing them closed and then using ... 08-15-2005 07:10 pm Body & interior stuff > Front (steel) Bumper (3 replies - 10913 views) I contacted Delta Motorsports. The plastic trim for the steel bumper has not been available for some time now. They said that some cars did ... 08-15-2005 06:57 pm Body & interior stuff > Front (steel) Bumper (3 replies - 10913 views) I want to restore my steel front bumper. Is the small crom looking trim (looks like piping) available somewhere? ... 08-05-2005 04:53 pm | |
Current time is 03:23 am | 1 2 |