According the Panasport catalog, they have the Jensen Healey listed as a 4 X 101.3. That is the exact same size that they have listed ...   07-03-2007 03:41 pm

Easier than lifting the engine, is lifting the car off of the engine (easier, that is, if you have a hoist that can lift that ...   06-28-2007 12:26 pm

mdutch wrote: Looking forward to some bling in my boot.  ;) Isn't that a rap song? ...   06-20-2007 12:15 pm

The spare tire carrier pivots on one end, and lowers on the other by turning the screw in the bottom of the trunk Mitch Ware #19670 ...   05-16-2007 11:56 am

Not sure what caused the failure. The symptom wasn't that it didn't pump at all, it just didn't pump very much. The car would idle ...   05-10-2007 06:33 pm

I went the expensive electronic SU fuel pump when I restored my car. It crapped out after two years.   Mitch Ware #19670 ...   05-10-2007 04:10 pm

Thanks Tom,   I'll check it out when I get a chance. (My wife and I opened a restaurant 4 months ago, and that on top of ...   05-03-2007 12:10 pm

I've been thinking about replacing my starter now too. I have a problem in that it is drawing too much current. I had this same problem ...   05-01-2007 02:18 pm

PPG code is 14926 and is available in laquer only   Mitch Ware #19670 ...   03-20-2007 03:23 pm

I did mine the same way Ron suggests, no trying to get input shafts lined up to mate the tranny to the engine, no trying ...   02-26-2007 12:17 am

I know of a guy here in Albany, NY that wants to sell his E-prod JH. He's been bugging me to buy it, but since ...   01-11-2007 04:27 pm

I'm not sure what the shop rates are of the place you are getting the work done. With that said, at the $48 per hour ...   11-16-2006 12:58 pm

VIN: 1111/19670 Condition: Restored Engine #: B74121 0715 Transmission #: 933-9 (5 speed) Axle #: 20M-4 Commission Date: 12/30/1974 (according to vin plate) Date of Manufacture: 1/15/1975 (according to Martin Robey) Car ...   11-14-2006 07:01 pm

Here is a shot of the new battery tray that I built. Mine was rusted and full of holes. I made a new one using ...   09-25-2006 04:33 pm

bring a gun?   Mitch Ware ...   09-08-2006 12:38 pm

    After chasing my tail on why my car was dieing, it came down to the fuel pump. I have one of the fancy-schmancy solid ...   08-17-2006 07:32 pm

Wow! another JH in the Albany/Schenectady area. I'm halfway in between in Niskayuna. Mitch Ware ...   08-17-2006 03:03 am

IIRC correctly, Mark is right. Its been a while since I was under my car. And that is a good thing Mitch Ware ...   07-28-2006 07:18 pm

I had my best luck by sandblasting it off.   Mitch Ware ...   07-27-2006 02:29 pm

Thanks, I like the color too. 1978 Jaguar Brooklands Green   Mitch Ware http://home.nycap.rr.com/mware/index.htm ...   07-16-2006 12:42 am

Gross Axle Weight Rating (GAWR): The GAWR is the maximum weight each axle is designed to carry safely. It includes the entire weight of the vehicle, ...   07-12-2006 02:42 pm

I applaude your efforts Erik, it has been a pleasure to follow your progress in bringing the Shark to life!   Mitch Ware ...   07-05-2006 12:34 pm

During the convention there a couple of years ago, Frank aranged for us all to go to the Lane Motor Museum, it is a must ...   06-26-2006 12:06 pm

A couple of things stand out, IIRC your plug gap should be 35 not 45. Also with pertronix timing should be 12^ advance. ...   06-16-2006 02:59 pm

OMG! Joe, you are selling some of your cars? I thought you were trying to corner the market.   Mitch Ware ...   06-06-2006 12:48 pm

I don't still have the instructions after 2+ years. I used the dry method though. I do remember that it was very important to make ...   06-01-2006 07:14 pm

I bought the re-usable gaskets from the club store, followed the directions to the letter. 8k miles and a valve adjustment later, not a single ...   05-31-2006 12:36 am

As an aside to the link of the illustration that Mark put up, A while ago I scanned in some of the parts list manaul ...   05-30-2006 11:01 pm

I believe it is at the top of the door at the back, right next to your shoulder when you are sitting down.   Mitch Ware ...   05-25-2006 06:49 pm

Take pictures before you take it apart so you can see where all the pieces go, where you need to rivet and where the screws, ...   05-24-2006 03:41 pm

Here is a bit of an explanation as to the different Toyota transmissions: http://en.wikipedia.org/wiki/Toyota_W_Transmission   Mitch Ware ...   05-23-2006 07:37 pm

because it has a ")." as part of the link.   Mitch Ware ...   05-02-2006 02:38 pm

I understand what you are saying RE prod. I just got my SCCA license last year and drove a '68 MGB. I will driving it ...   04-27-2006 08:47 pm

I got a call last week, a local guy wants to know if I'm interested in buying his E Production JH. hmmm, how could I ...   04-27-2006 06:23 pm

I'm taking mine out of storage this weekend. My E-production car (MGB) will be done and ready for this season's racing  this weekend too. I'm ...   04-25-2006 09:56 pm

Here you go, http://www2.kjware.net:8079/mitch/interior_2.JPG Mitch Ware ...   04-10-2006 12:08 pm

I just got today's mail and there was the new cloisonne. As expected it is a work of art and a thing of beauty. I ...   04-08-2006 10:44 pm

Of course Mark's major gaffes are still more accurate than most things I say.   Mitch Ware ...   04-08-2006 08:14 pm

I put the carpathian elm burl in my car and I get a lot of compliments on how it looks.  I have even seen people ...   04-08-2006 01:01 am

hmm, my Hagerty policy has no use or mileage limitations. The only two requirements were that it not be my main driver, and it be ...   04-06-2006 06:55 pm