| ||||
| ||||
|
||||||||||
| Posts by Mark Rosenbaum | |
|---|---|
| 532 posts | Showing posts 521-532 of 532 |
| Body & interior stuff > 1st time carpet install: DMS kit vs.$8 sq. yard marine carpet (7 replies - 20842 views) I installed one of Delta's brown carpet kits about four years ago. It went in easily enough, everything fit reasonably well, I haven't had any trouble to ... 03-22-2005 02:39 pm Suspension > Suspension bolts (13 replies - 24416 views) One of the drawbacks of owning 30-year-old cars is that sometimes the available replacement parts aren't quite exact duplicates of the originals. This, alas, is ... 03-21-2005 02:16 pm Carburetors > Zenith Stromberg Carburetor Fuel Mixture Needles (3 replies - 26592 views) According to the shop manual, the B1CM needles were used until engine 4802. I should have mentioned that but to be frank I just didn't ... 03-21-2005 12:35 am Body & interior stuff > Doors (5 replies - 13484 views) If yours are like the presumed-original ones I found on my car, the flat disk at the top is only 3/4 of a full circle. In ... 03-20-2005 07:35 pm Carburetors > Zenith Stromberg Carburetor Fuel Mixture Needles (3 replies - 26592 views) In the Stromberg carburetor, the amount of fuel delivered to the engine is determined by the main jet, which is of fixed diameter, and the ... 03-19-2005 01:28 am Carburetors > Zenith Stromberg Carburetor Schematic (0 replies - 9204 views) Here's a drawing showing in schematic form how a Stromberg carb works. It may be of some value in helping folks understand them.
... 03-18-2005 10:27 pm Brakes > TR6 master cylinder conversion (22 replies - 67472 views)
Originally posted July 2003.
============================================================
Recently the master cylinder (M/C) in my JH began exhibiting unmistakeable signs of incipient failure. Having heard that the success rate when ... 03-17-2005 09:36 pm Electrical & Instruments > Smiths Small Gauges (1 reply - 44847 views)
Gauge questions seem to come up fairly often. Hoping to answer some of these, I've gathered data from various sources on the internet and elsewhere, and ... 03-15-2005 06:02 pm Miscellaneous > O-rings (2 replies - 14356 views)
An update of stuff originally posted on the old board, re-posted here per Greg Fletcher's comments elsewhere on this board. Information is believed reliable but use it at ... 03-15-2005 03:37 pm Ignition > Distributor (4 replies - 14327 views) In my younger days, shade trees were generally in short supply and much of my Brit car repairing was done in ditches, culverts, or the occasional grassy ... 03-14-2005 03:36 pm Ignition > Distributor (4 replies - 14327 views) Most JHs using Strombergs seem to need a fair amount of choke until they warm up. If you need 3/4 choke for a warm engine, ... 03-14-2005 01:43 am Engine & Transmission > Front and Rear main seals, timing gear removal (6 replies - 15418 views) I don't think you put the rear seal in correctly. JH Service Bulletin 74-9 says the seal is to be inserted from the outer (rear) ... 03-12-2005 11:14 pm | |
 Current time is 08:03 am |   ... 9 10 11 12 13 14 |
