| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| Ignition Switch replacement | Rate Topic |
| Author | Post |
|---|
| Posted: 04-05-2007 01:16 am |
|
1st Post |
|
Dave Sollish Member
|
My ignition switch has failed so I need to come up with a fix. Does anyone know if the MGB switch & lock assembly part #319-120 from http://www.thebhive.com work?
|
||||||||||||||
| |||||||||||||||
| Posted: 04-05-2007 03:20 am |
|
2nd Post |
|
Mark Rosenbaum Member 
|
I don't think this would work. The MG part might perhaps fit mechanically, but it seems to lack the steering lock mechanism and release button. Also, you'd have to replace its electrical connector with one compatible with the JH wiring. Finally, there is no connector for the wire to the key-in-ignition warning connector. On a side note, you might want to remove what looks to be your home address from the 'homepage' line in your profile.
|
|||||||||||||
| ||||||||||||||
| Current time is 03:05 pm | |
| > Jensen Healey & Jensen GT Tech > Electrical & Instruments > Ignition Switch replacement | Top |
