Home 
> Jensen Healey & Jensen GT Tech > Engine & Transmission > Adding Dowels to the Bearing Housing to Block Studs

 Moderated by: Greg Fletcher  
AuthorPost
Dan Eiland
Member
 

Joined: 03-18-2005
Location: El Paso, Texas USA
Posts: 159
Status: 
Offline
Where can I purchase the correct dowels for the Main bearing housing to block studs? I want to add them to all 10 studs to stiffen the bottom end before I have the engine line bored for my 2.2L conversion. I guess I will try DB tomorrow and see if they have them.

Dan Eiland
Member
 

Joined: 03-18-2005
Location: El Paso, Texas USA
Posts: 159
Status: 
Offline
Since no one responded I called Dave Bean and purchased what I needed. Just a FYI if anyone else was interested.

Joel
Member
 

Joined: 07-01-2005
Location: San Diego, USA
Posts: 184
Status: 
Offline
Dan:

Just a quick thanks for posting all your info!  I'm HOPING to start on the same project in 6 months or so and really appreciate all your imput.  Before I start I'll make sure to drop you a line and pick your brain.  Right now everything seems to be running fine on the stock motor so I'm just taking my time collecting the parts so I can get my spare up and running.

Thanks again!

Dan Eiland
Member
 

Joined: 03-18-2005
Location: El Paso, Texas USA
Posts: 159
Status: 
Offline
Joel,

I hope that is what this place is all about, sharing what we know with those who need it and asking those who know for assistance when we need it. I have taken a lot of digital photos as I proceed. If you would like to see something before you jump in just let me know and I'll post it here.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems