Home 
> Jensen Healey & Jensen GT Tech > Body & interior stuff > Madera Concepts Dash Installation

 Moderated by: Greg Fletcher  
AuthorPost
73healey
Member
 

Joined: 03-13-2006
Location: Lodi, California USA
Posts: 25
Status: 
Offline
I have purchased and received the dash kit from Madera Concepts. Everything looks pretty straight forward except the installation of the piece to the left of the steering column. I have an early car but it has the stuck on veneer to a metal plate. Do I adhere the new wood to the metal plate? If I do this, how do I get the bottom molding to line up correctly as it has now been pushed out about 1/4 inch? Can I assume that the clock trim piece is glued also to the metal plate? If glue is used, what is the correct type?

Any suggestions would be helpful. Thanks


Jim



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems