Home 

 Moderated by: Greg Fletcher  
AuthorPost
andrewo
Member
 

Joined: 06-01-2005
Location: San Diego, California USA
Posts: 51
Status: 
Offline
I started installing the door rubber, but it did not fit well over the bottom portion of the opening. Was I supposed to cut the carpet back so that the flange is bare? See picture.

 

Attachment: JH PS door sill small.jpg (Downloaded 88 times)

colinw59
Member


Joined: 02-14-2006
Location: Bloomfield/Hebron, Connecticut USA
Posts: 147
Status: 
Offline
The carpet butts up to the inside lip of the inner and outer rocker panel seam. It does not fold over it. If you do this the resulting section will be too thick and you wont be able to get the weatherstip over it.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems