| ||||
| ||||
| Moderated by: Greg Fletcher |
|
||||||||||||||
| roll bar | Rate Topic |
| Author | Post |
|---|
| Posted: 05-10-2006 12:35 am |
|
1st Post |
|
Thomas Thomson Member
|
Hey race car guys: Where is the best place to mount a roll bar? I can't find anything heavy enuf to instill confidence. Tom
|
||||||||||||||
| |||||||||||||||
| Posted: 05-10-2006 03:00 pm |
|
2nd Post |
|
Pat Connor Member 
|
All possible mounting spots are in sheet metal. The proper way to mount the rollbar is with 1/8" plates on the underside to spread the load as wide as possible.
|
|||||||||||||
| ||||||||||||||
| Posted: 05-10-2006 05:23 pm |
|
3rd Post |
|
Judson Manning Member 
|
Check your sacntioning body for specific rules. Me thinks SCCA may require 3/16" backing-plates. Alternatively, weld-in 3/16" stock and create a 'box' between the floorboard and vertical surfaces. This will provide ample distribution area.
|
||||||||||||||
| |||||||||||||||
| Current time is 09:22 am | |
| > Jensen Healey & Jensen GT Tech > Miscellaneous > roll bar | Top |
