Home 

 Moderated by: Greg Fletcher  
AuthorPost
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 421
Status: 
Offline
Can anyone tell me what size nuts are used to mount the side marker lights to the inside of the body? I beleive these are the same as what holds the rear trim bits to the body.

I'm also trying to figure out what size bolt I need for the front bumper flasher lens. Any ideas?

Thanks!

Jim Ketcham
Member
 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 192
Status: 
Offline
Side marker lights use 6-32 nuts.

For steel bumper vehicles,

The front bumper flasher unit uses 8-32 nuts.

The front bumper flasher lens uses 6-32x1 1/4 inch long machine screws.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems