Engine & Tranny Install - Engine & Transmission - Jensen Healey & Jensen GT Tech -

> Jensen Healey & Jensen GT Tech > Engine & Transmission > Engine & Tranny Install

Author

Post

JH12947
Member

Joined:	07-14-2022
Location:	Penticton, British Columbia Canada
Posts:	40
Status:	Offline

I have the engine and tranny ready to back in the car. Looks like the manual recommends installing the engine and tranny as separate units. Should I

Install engine from above and then install tranny as a separate unit from below
Install engine and tranny as a unit from above
Drop the front subframe and lower the body onto the engine/tranny/subframe assembly

I have a gantry crane and 2 post lift so all are doable. I'd normally go the subframe route but don't really want to uninstall it and disconnect brake lines if it goes in easily from the top.
Also any insight into the best time to install the header and steering shaft would be appreciated.
Thanks,

Corey

redracer
Member

Joined:	09-10-2012
Location:	BROOKHAVEN, Georgia USA
Posts:	628
Status:	Offline

Finally got a 2 post lift, and like you, the subframe way to install if one uses the lift.
However, having for year done it with an engine hoist(not a gantry) jacking up the rear as high as possible in relation to the front is fairly easy, WITH the tm(4 0r 5 spd) attached.
Also, you can bend/adjust the pipes after the headers so they don't hit the transmission mounting bracket by attaching the bracket while it's still out is MUCH easier than after installation.
call/email/SKYPE if you wish.
bruce/RedRacer

JH12947
Member

Joined:	07-14-2022
Location:	Penticton, British Columbia Canada
Posts:	40
Status:	Offline

Thanks Bruce. Sounds like the subframe route is the way to go. I'll take you up on your offer if I run into any issues.