Home 
Home Search search Menu menu Not logged in - Login | Register

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Steering geometry  Rate Topic 
AuthorPost
 Posted: 11-19-2021 01:10 pm
  PM Quote Reply
1st Post
jomac
Member
 

Joined: 09-16-2016
Location:  
Posts: 71
Status: 
Offline
I am planning on refurbishing my front suspension, I believe my camber angle is too negative angle. Specs states toe in 0 - .09 inch , camber - 1 degree +- .5 degree , and +2 degrees for caster angle but is not adjustable. I have new upper and lower ball joints and tie rod ends and boots. I am looking at replacing all bushings. My question is what controls the camber angle adjustment? , the manual doesn't explain?

Back To Top PM Quote Reply  

 Posted: 11-19-2021 10:53 pm
  PM Quote Reply
2nd Post
redracer
Member
 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 617
Status: 
Offline
There is no adjustment for camber. If you wish to adjust it, you will need to make a sliding plate for the top ball joint and elongate the original holes where the original solid rivets went through.

Back To Top PM Quote Reply

 Posted: 11-20-2021 11:05 am
  PM Quote Reply
3rd Post
jomac
Member
 

Joined: 09-16-2016
Location:  
Posts: 71
Status: 
Offline
Thanks for the info, I checked my camber it's within specs. I'll need to rotate my tires more , they're showing more wear on the inside.
I did a little research , has anyone tried to install camber bushings in the upper control arms?

Last edited on 11-20-2021 03:47 pm by jomac

Back To Top PM Quote Reply  

Current time is 06:22 am  
> Jensen Healey & Jensen GT Tech > Miscellaneous > Steering geometry Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems