Home 
> Jensen Healey & Jensen GT Tech > Body & interior stuff > How to remove floor console between seats

 Moderated by: Greg Fletcher  
AuthorPost
dlwharleyman
Member
 

Joined: 09-06-2017
Location:  
Posts: 5
Status: 
Offline
Need to remove the console to get to the back of a switch that was installed. Not sure how many bolts or screws there are and where they are located.

redracer
Member
 

Joined: 09-10-2012
Location: BROOKHAVEN, Georgia USA
Posts: 626
Status: 
Offline
There are 2, #2 size posidrive/crosspoint screws in the very rear bottom(outside) under the rear deck carpet. Once these are removed, remove the shift knob and place in a gear so the lever points down and to the rear. Loosen the cord wrapped around the shift boot and slide the entire console to the rear to JUST clear the front vertical radio/heater piece. Now from the passenger side, lift up the console slightly to expose the 3 wires going to the cigarette lighter. The purple wire is always "HOT" so be sure it is protected from grounding.

dlwharleyman
Member
 

Joined: 09-06-2017
Location:  
Posts: 5
Status: 
Offline
Thank you. I'll try that.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems