Home 

 Moderated by: Greg Fletcher  
AuthorPost
buba1965
Member
 

Joined: 06-20-2017
Location:  
Posts: 3
Status: 
Offline
Does anyone have a set of 104 MOP cam gears they want sell,just got running after sitting for 30 years.Right now I'm running 107 cam @ 110 MOP would like to get a little more out of it.

Jensen Healey
Super Moderator


Joined: 03-11-2005
Location: San Anselmo, California USA
Posts: 976
Status: 
Offline
Welcome to the message board. Try Mike Taylor at lotusbits.com.

Schorse
Member


Joined: 07-11-2013
Location: Hannover, Germany
Posts: 26
Status: 
Offline
Where abouts are you located? I have a spare set I think but I am not home to check at the moment

buba1965
Member
 

Joined: 06-20-2017
Location:  
Posts: 3
Status: 
Offline
I'm in Quakertown,PA.USA.

Schorse
Member


Joined: 07-11-2013
Location: Hannover, Germany
Posts: 26
Status: 
Offline
I think you might be able to source some vernier pulleys from one of the typical suppliers. I am located in Germany, so the shipping cost is probably higher than what the pulley is worth... sorry

DonBurns
Member
 

Joined: 09-18-2015
Location: Fullerton, California USA
Posts: 47
Status: 
Offline
You might check with JAE in California also. I know they have the half-round type. Not sure about trapezoidal.

http://www.jaeparts.com

buba1965
Member
 

Joined: 06-20-2017
Location:  
Posts: 3
Status: 
Offline
OK Thanks.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems