Home 

 Moderated by: Greg Fletcher  
AuthorPost
Dick Fickey
Member
 

Joined: 04-05-2007
Location: Lake Havasu, Arizona USA
Posts: 27
Status: 
Offline
Has anyone painted a hard top. I have two of them. One has some minor scratches. I want to repair these and then paint it. Not sure what would be the best paint to use. Any suggestions.

Sander
Member


Joined: 03-15-2005
Location: Peachtree Corners, Georgia USA
Posts: 107
Status: 
Offline
Just a suggestion ... you'll want to decide what "sheen" you're looking for.

https://duplicolor.com/product/trim-and-bumper-paint


This has flat or gloss available:

https://duplicolor.com/product/vinyl-and-fabric-coating

Last edited on 06-07-2017 11:45 am by Sander

DonBurns
Member
 

Joined: 09-18-2015
Location: Fullerton, California USA
Posts: 147
Status: 
Offline
I used "vinyl paint" that was available at the auto paint store. Also used it on the steering wheel. It will say something about being good for upholstery and hard plastic surfaces. Sprays on thin, so may or may not cover scratches.

Dick Fickey
Member
 

Joined: 04-05-2007
Location: Lake Havasu, Arizona USA
Posts: 27
Status: 
Offline
Thanks for the recommendations. I have a spare wheel I am going to try it on before the top. I also need to replace the rubber seals. Need to find a source.

Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
https://www.macgregorukcarparts.com/

one source for seal's. no affiliation

Brett

Dick Fickey
Member
 

Joined: 04-05-2007
Location: Lake Havasu, Arizona USA
Posts: 27
Status: 
Offline
Thanks Brett for the link. I am also checking Metro and Steele rubber products to see if they a profile close.

Rick in Miami
Member
 

Joined: 02-17-2015
Location:  
Posts: 48
Status: 
Offline
IIRC I used a TR6 header rail seal for the JH header and Triumph or MG door seals to seal around the side windows. My top to body seal was OK.

I am still trying to source the rear window chrome/mylar trim/lockstrip. Any suggestions?

Thanks ~ Rick

Dick Fickey
Member
 

Joined: 04-05-2007
Location: Lake Havasu, Arizona USA
Posts: 27
Status: 
Offline
Thanks for the leads. I have two tops. One is a factory and one is after market. The factory top has a black lockstrip in the rubber rear window molding and the after market top has a chrome lockstrip. I need to get new window molding for both. If you run across any sources let me know.

Brett Gibson JH5 20497
Member
 

Joined: 03-17-2005
Location: Hilton, New York USA
Posts: 798
Status: 
Offline
My 1986 Volkswagen Westfalia has a similar plastic lock strip around it's windows, I know you can get it both in black or chrome, Go-Westy and Bus Depot I believe carry it. I have to mention I have not removed the lock strip from my hard top to compare them together, but visually they do look alike.

Brett

Dick Fickey
Member
 

Joined: 04-05-2007
Location: Lake Havasu, Arizona USA
Posts: 27
Status: 
Offline
Just got my catalogs from Metro and Steele Rubber Products. I noticed the Steele has locking strips with chrome face on page 5.

Rick in Miami
Member
 

Joined: 02-17-2015
Location:  
Posts: 48
Status: 
Offline
Brett & Dick - Thanks for sharing but the sizes and shapes won't work. I initially thought a TR4-6 windshield trim might work but found it to be wrong as well. Since the top already has the black lock strip installed, I guess I'll just stick with that.



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems