| Moderated by: Greg Fletcher | ||
| Author | Post | |||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
JHPSow Member
|
Hi, I have a UK Jensen-Healey Mk1 1972. Project: Nut-Bolt, Bare Metal Re-Build. I'm replacing inner/outer sills & floor pans, both sides. I have these parts and work is progressing. I now need: - O/S/F (R/H) longitudinal under floor - Part No. 91629 - N/S/F (L/H) longitudinal under floor - Part No. 91629 - O/S B (R/H) Post (c/w reinforment panel, holds the door lock catch), I have purchased a N/S, but both sides rusty. Martin Robey are out of stock, open to suggestions. Happy to pay shipping to UK. Please reply below. Many thanks, Oakleigh Bristol - UK |
|||||||||
|
Screenplay Member
|
Hi; I'm not certain what you need, but perhaps this item on ebay is one of them: http://www.ebay.com/itm/JENSEN-HEALEY-RIGHT-REAR-PILLAR-ASSEMBLY-/232168378822?hash=item360e5051c6:g:inwAAOSwo4pYSZEn&vxp=mtr Clinton |
|||||||||
|
Jensen GT Member 
|
I have this Parts' Attachment: WP_20180124_19_11_49_Pro.jpg (Downloaded 56 times) |
|||||||||
|
Jensen GT Member
|
Foto Attachment: WP_20180124_19_11_05_Pro.jpg (Downloaded 58 times) |
|||||||||
|
Jensen GT Member
|
Jensen Number: 98202 Front Crossmember-seat slide LH. 97637 Front Crossmember-seat slide RH. 98265 Rear Crossmember-seat slide LH 91034 Rear Crossmember-seat slide RH. |
|||||||||
|
redracer Member
|
Oakleigh: I assume you are talking about the long flanged "U" shaped channels that run under the center of each floor? (could not find the item in my factory parts book; was not even a picture of it?). We have made them before and should be fairly simple for any fabrication shop and not very expensive. We have also made the shorter flanged channel that the seats bolt onto, only we used heavier metal(again, fairly simple for a fabrication shop) |
|||||||||