Home 

 Moderated by: Greg Fletcher  
AuthorPost
chiromaster
Member
 

Joined: 03-22-2010
Location: Phoenix, Arizona USA
Posts: 37
Status: 
Offline
Has anybody replace their speedometer gear? How do you remove it from the main shaft? I don't want to damage anything further than it already is.

atgparker
Member


Joined: 06-23-2013
Location: Mission Viejo, California USA
Posts: 78
Status: 
Offline
On the shaft and inside the steel inner part of the gear there is a ribbed piece of sheet metal which is sort of sprung loaded between the output shaft's boss were the gear is positioned and the ID of the gears metal hub. I have driven the gear off the shaft with a hammer and punch being careful to go around and around to move the gear down the shaft as evenly as I can.

Once you have serviced the the 4 speed gear box I used some tubing to set the gear back onto the shaft as this is square and keeps the pressing operation even on re-positioning the gear.

Last edited on 05-04-2016 07:27 pm by atgparker



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems