Home 
> Jensen Healey & Jensen GT Tech > VIN Database for Jensen Healey & Jensen GT > '74 JH Transmission Speedometer Drive Gear

 Moderated by: Greg Fletcher  
AuthorPost
Goldentouch
Member
 

Joined: 02-18-2016
Location:  
Posts: 1
Status: 
Offline
Recently replaced the Speedo cable on my 74 JH only to have cable-end at the transmission strip. Indication is the transmission drive gear maybe warn or its self locking up or.

Have others experienced this and is there a source to replace the Speedo drive gear? Thanks!

Randallclary@icloud.com
Member
 

Joined: 10-04-2013
Location: Riverside, California USA
Posts: 95
Status: 
Offline
I seethat you have replaced the cable. Did you check to see that the output of the transmission speedo gearbox is actually turning. I have a problem where the other end of the speedo cable at the speedometer is worn and does not engage the female portion of the meter. I hope that replacing the cable at weil solve the problem and that the female portion of the cable input to the meter is not worn. If it is, I wonder what I do then. I did notice that when I removed the meter itself, the mech was very gummed up. I cleaned the meter up and sprayed WD 40 to loosen things up. They were really binding up. Make sure that things are free before you put everything back together.

I did have good free turning of the speedo cable to the speedometer, just gummed up which probably broke the cable tip and hopefully not the input of the meter itself. I know that I ahve to replace the cable.

I will check for sources for the gearbox,have you checked the club store or Delta?

Last edited on 02-20-2016 06:21 am by Randallclary@icloud.com



UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems