Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Suspension > Bushing replacement on front axle control rods

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Bushing replacement on front axle control rods  Rate Topic 
AuthorPost
 Posted: 07-12-2005 09:50 pm
  PM Quote Reply
1st Post
Frank Schwartz
Guest
 

Joined: 
Location:  
Posts: 
Status: 
Offline
Well, I need to replace the bushings, part numbers 52, 53, 54 and 55 on the control rod #50. Before I dive in, I might say that the service manual says little or nothing about it. If I remove the rear nut #51 can I slid the whole thing forward enough to replace the bushing and sleeve without having to remove the control rod where it bolts to the lower arm?

Back To Top PM Quote Reply  

 Posted: 07-13-2005 12:34 am
  PM Quote Reply
2nd Post
Greg Fletcher
Administrator


Joined: 03-11-2005
Location: Lake Nacimiento, California USA
Posts: 421
Status: 
Offline
I'm remembering that those front bolts will need to be removed so that you can pull the rod out of the subframe opening and remove the other bushing. Now is a good time to go through the entire front suspension, if needed. You'll need to get the front end realigned whenever those bushing get changed.

Back To Top PM Quote Reply

Current time is 11:59 pm  
> Jensen Healey & Jensen GT Tech > Suspension > Bushing replacement on front axle control rods Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems