Home 
Home Search search Menu menu Not logged in - Login | Register
> Jensen Healey & Jensen GT Tech > Ignition > Spring behind distributor

 Moderated by: Greg Fletcher
New Topic Reply Printer Friendly
Spring behind distributor  Rate Topic 
AuthorPost
 Posted: 02-27-2015 02:24 am
  PM Quote Reply
1st Post
Bfitz241
Member
 

Joined: 02-05-2015
Location: Saint Augustine, Florida USA
Posts: 159
Status: 
Offline
In the process of installing my distributor I stuck my finger in the hole and felt the spring in the pump was still there. Does that need to center perfectly on the distributor drive? in other words, should I remove the spring and place it on the center drive and install the whole assembly?
Second question, I found a small spring, about 3/4" long, maybe 3/16 diameter laying on the engine under the distributor...is this a crucial part or extra junk on my engine? It looks like a large pen spring....Thanks for any input.

Back To Top PM Quote Reply  

 Posted: 02-27-2015 04:02 pm
  PM Quote Reply
2nd Post
Jim Ketcham
Member
 

Joined: 03-13-2005
Location: Salt Point, New York USA
Posts: 192
Status: 
Offline
The spring behind the distributor should mount in the recessed hole in the oil pump shaft. The distributor butts up against in when in place.

Without seeing the other spring I can not be sure where it came from.
My best guess is it is either the throttle return spring or the pump rod spring from one of your Dellorto carbs.

Where in NY are you?

Back To Top PM Quote Reply

 Posted: 02-27-2015 08:19 pm
  PM Quote Reply
3rd Post
Bfitz241
Member
 

Joined: 02-05-2015
Location: Saint Augustine, Florida USA
Posts: 159
Status: 
Offline
the mystery spring turned out to be the idle mixture screw spring from one of the Dellortos...I'm in Massapequa, Long Island

Back To Top PM Quote Reply  

Current time is 12:46 am  
> Jensen Healey & Jensen GT Tech > Ignition > Spring behind distributor Top




UltraBB 1.172 Copyright © 2007-2011 Data 1 Systems